Scribd
Upload
187 views1 page

Utp 83 FN

This document provides information on a graphite-basic coated FeNi stick electrode classified as E C NiFe-11 and E NiFe-Cl. It can be used for surfacing and joining various cast iron grades and steel. The electrode has an excellent melting performance and provides a spatter-free deposit that is machinable, tough, and crack-resistant. Recommended welding parameters including amperage ranges are provided for various electrode diameters.

Uploaded by

Sun Sun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
187 views1 page

Utp 83 FN

This document provides information on a graphite-basic coated FeNi stick electrode classified as E C NiFe-11 and E NiFe-Cl. It can be used for surfacing and joining various cast iron grades and steel. The electrode has an excellent melting performance and provides a spatter-free deposit that is machinable, tough, and crack-resistant. Recommended welding parameters including amperage ranges are provided for various electrode diameters.

Uploaded by

Sun Sun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

UTP 83 FN

graphite-basic coated FeNi stick electrode

Classifications
EN ISO 1071 AWS A5.15
E C NiFe-11 E NiFe-Cl
Characteristics and field of use
UTP 83 FN is suitable for surfacing and joining of all commercial cast iron grades, such as lamellar
grey cast iron and nodular cast iron, malleable cast iron and for joining these materials to steel or
cast steel. This stick electrode is particularly used where a high deposition rate is needed.

UTP 83 FN has an excellent melting performance and the easily controllable transfer provides a
spatterfree deposit of perfect appearance. The weld deposit is easily machinable with cutting tools,
tough and crack-resistant.

Hardness of the pure weld metal: approx. 190 HB

Typical analysis in %
C Ni Fe
1,3 52,0 balance
Welding instruction
The casting skin and impurities have to be removed from the welding area. Weld with low amper-
age and short arc. For the purpose of stress relief in case of difficult weldings, peen the weld metal
and reduce the heat input by welding short beads.

Welding positions

Current type DC (+) / AC

Recommended welding parameters


Electrodes Ø x L [mm] 2,5 x 300 3,2 x 350 4,0 x 350
Amperage [A] 50 – 70 70 – 100 100 – 130

All information provided is based upon careful investigation and intensive research. 03/2014 Rev. 0
However, we do not assume any liability for correctness and information is subject to change without notice. www.voestalpine.com/welding

You might also like