Scribd
Upload
107 views1 page

Configuration Dcom Citizen Fanuc

This document contains configuration parameters for communication between a Citizen machine tool equipped with a Fanuc controller. It lists the baud rate, parity, data length, handshake protocol, timeout value, and other settings for transmitting data via an adapter. The values configure binary transmission of data in 7-bit format with hardware handshake enabled and an infinite timeout period.

Uploaded by

David Martinez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
107 views1 page

Configuration Dcom Citizen Fanuc

This document contains configuration parameters for communication between a Citizen machine tool equipped with a Fanuc controller. It lists the baud rate, parity, data length, handshake protocol, timeout value, and other settings for transmitting data via an adapter. The values configure binary transmission of data in 7-bit format with hardware handshake enabled and an infinite timeout period.

Uploaded by

David Martinez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Configuration Dcom Citizen-Fanuc

Citizen équipée de commande Fanuc 0T

Adaptateur Configuration de la transmission


Paramètre Valeur
$BaudRate (300-115200) 2400
$Parity (0: even; 1: odd; 2: none; 3:mark; 4:space) 0
$CtrlParity ( 0: off; 1: on)1 1
$StopBit (1, 2) 2
$DataLength ( 5, 6, 7, 8) 7
$HandShake ( bit0 : Xon/Xoff ; bit1 : hardware RTS/CTS ; bit2 : hardware DSR/DTR) 1
$XOnChar ( decimal code of character ) 19
$XOffChar ( decimal code of character ) 17
$TimeOut ( time in secondes; 9999 means endless Timeout) 9999
$TransferDisplay ( 0: brief; 1: full ) 1
$TransferType ( 0: Binary; 1: Texte ) 1
$Conversion ( 0: off; 1: on ) 1
$LineLimitChar ( decimal code of char ) 0
$SpacePack ( 0: off; 1: on; 2: supress ) 0
$StartStoring ( decimal code of char ) 37
$StopStoring ( decimal code of char ) 37
$BeginChar ( decimal code of char ) 0
$EndChar ( decimal code of char ) 0
$NewLineSend ( decimal code of chararacters: CR = 13, LF = 10 ) 13 10
$NewLineRec ( decimal code of chararacters: CR = 13, LF = 10 ) 0
$BynaryFilter ( decimal code of mask ) 255
$IsoFilter ( 0: off; 1: receive; 2: transmit; 3: receive & transmit) 0
$RxCharFilter ( decimal code of chararacters ) 0
$TxCharFilter ( decimal code of chararacters ) 0
$BlocSend ( size of bloc send in one time ) 1
$TimeBetweenBloc ( time in miliseconds; 0 means no Time) 999

You might also like