Service Manual (Hwd-C1200txve-U Ce0gd3e0d00)

Download as pdf or txt
Download as pdf or txt
You are on page 1of 31

SERVICE MANUAL

HWD-C1200TXVE

Order No.FL1003S006V1.1

Front Load Washing Machine


MODEL: HWD-C1200TXVE/ME
HWD-C1000TXVE/ME
HWD-C1200TXVE-U
HWD-C1200TXVE-F
HWD-C1200TXVE-E
HWD-C1200TXVEME-U

WARNING
This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not
contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product. Products powered by
electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service or repair the product or
products dealt with in this service information by anyone else could result in serious injury or death

C 2010 Haier Washing Machine


All rights reserved. Unauthorized copying and distribution is a violation of law.

Haier Group

Haier Washing Machine


SERVICE MANUAL
HWD-C1200TXVE

Er10
rror
E message:The water level sensor circuit short cut or open
Troubleshooting:

Check if the wire of water levle sensor


Y Connect it well
is connected properly

Check if the water levle sensor Y e


Rplace it
is damaged

eplace
R C
PB

Er12
Failure information: drying waterlevel sensor abnormity
Clean water switch hose and air
Check if water switch hose and air collector Y
collector
are jammed
N

Pll out water switch inserts and turn on


u
power, then set wash mode. While water Replace water pressure switch
is entering at the position of 1/4g lass
window, check the resistance between Y
and , is it ?
0 Ch eck the resistance
between and , is it infinite?
N

eplace
R C
PB

Er13
Failure information:drying heater abnormity
Troubleshooting:

Check if the wire of drying


heating is connected properly Connect it well
N
Y

drying heating is short cut or open


Y Replace the drying heating
N

Replace PCB

value washing machine will not spin and run in a low speed to avoid abnormal vibration and noise.

1.
2. Lower the wet weight of laundry pieces by wringing manually and placing them back in the drum in symmetrical position.
3Take out and replace the laundry pieces into the drum in a more balanced position on the inner wall of the drum.
4. Add 1 or 2 pieces of laundry into the drum to lower the unbalance.
5.
6. In case the failure persist please send a technician to check it in home.
Haier Washing Machine
SERVICE MANUAL
HWD-C1200TXVE

3.Wiring Circuit

X3-2 X3-3 X5-1 X3-1 X2-4 X2-3

X1-3
X1-4

Door Lock
X1-3
X8-1
X1-1 X8-2
X1-2
X4-1
X4-2 X1-5

X1-4

Power Switch
X4-3
X4-1

TP

Washing Machine

You might also like