Scribd
Upload
4K views1 page

FAULT CODE 121 - Engine Speed/Position Sensor Circuit - Lost One of Two Signals From The Magnetic Pickup Sensor

The document provides troubleshooting steps for a fault code related to an engine speed/position sensor circuit issue. It details checking the engine speed sensor, engine harness, and extension harness for damage or electrical faults. The final step is to clear any fault codes.

Uploaded by

Donald Santana
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4K views1 page

FAULT CODE 121 - Engine Speed/Position Sensor Circuit - Lost One of Two Signals From The Magnetic Pickup Sensor

The document provides troubleshooting steps for a fault code related to an engine speed/position sensor circuit issue. It details checking the engine speed sensor, engine harness, and extension harness for damage or electrical faults. The final step is to clear any fault codes.

Uploaded by

Donald Santana
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

File: 01-t05-121 Page 1 of 15

FAULT CODE 121 - Engine Speed/Position Sensor Circuit - Lost One of Two
Signals from the Magnetic Pickup Sensor
TROUBLESHOOTING SUMMARY

CAUTION
To reduce the possibility of damaging a new engine control module, all other active fault codes must be
investigated prior to replacing the engine control module. To reduce the possibility of pin and harness
damage, use the following test leads when taking a measurement: Part Number 3822758 - male Deutsch/
AMP/Metri-Pack test lead Part Number 3822917 - female Deutsch/AMP/Metri-Pack test lead.

STEPS SPECIFICATIONS SRT CODE


STEP 1: Check the engine speed sensor.
STEP 1A: Inspect the sensor and engine No damaged pins
harness connector pins.
STEP 1B: Inspect the engine speed No damaged engine speed
sensor. sensor
STEP 1C: Check for a short circuit to More than 100k ohms
engine block ground.
STEP 1D: Check for an open circuit. 1k to 2k ohms
STEP 1E: Check for short circuit between More than 100k ohms
coils.
STEP 2: Check the engine harness.
STEP 2A: Inspect the engine harness and No damaged pins
the extension harness
connector pins.
STEP 2B: Check for short circuit to engine More than 100k ohms
block ground.
STEP 2C: Check for an open circuit. Less than 2k ohms
STEP 2D: Check for a short circuit from More than 100k ohms
pin to pin.
STEP 3: Check the extension harness.
STEP 3A: Inspect the extension harness No damaged pins
and the engine control module
connector pins.
STEP 3B: Check for short circuit to engine More than 100k ohms
block ground.
STEP 3C: Check for an open circuit. Less than 2k ohms
STEP 3D: Check for a short circuit from More than 100k ohms
pin to pin.
STEP 4: Clear the fault codes.
STEP 4A: Disable the fault code. Fault Code 121 inactive
STEP 4B: Clear any inactive fault codes. All fault codes cleared

2008 Cummins Inc., Box 3005, Columbus, IN 47202-3005 U.S.A. Printed from QuickServe Online.
All Rights Reserved. Last Modified: 20-Apr-2012

You might also like