Free-Standing Bathtub: Installation Instructions

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 7

Free-Standing Bathtub

Installation Instructions
Contents:
Product drawing ....................................1

Installation steps....................................2

Cleaning and maintenance tips...............3

Caution...................................................4

1.Product Drawing
The place for drainer

2.Installation Steps

2-1. Remove the Bath from the carton.

Ensure the Bath does not come into contact with rough surfaces.

Rough surfaces will scratch your Bath.

Always ensure that the Bath is placed on cardboard or carpets during installation.

Place the Bath in position for installation.


2-2. Adjust the feet make sure the Bath is level.

Only if the Bath is level will all water drain to the waste outlet.Please ensure legs
are adjusted in line with the base of bath.Check the sits flat.

2-3. Connect the Bath to the waste outlet.


2-4. Finally you need to do a final test for drainage.

Ensure that the thin masking plastic adhered to your bath during manufacture has
been removed.Fill the Bath with water and check that ALL the water flows freely to
the waste outlet.

A small amount of water may pool owing to surface tension.

2-5. Apply a thick layer of silicon sealant around the bath outline allow it set 24
hours.This installation guide,the installation of waste connection should be only
suitably by qualified person.

3. Cleaning and maintenance tips

3-1. In time to clean. To clean convenient, it is suggested that immediately wash


the bath after taking a bath. This time will be expanded easily to remove dirt and
soapsuds, after a long time will accumulate in the tub wall and difficult to remove,
especially in places where hard water quality in high calcium content, after a long
time will form macular at the bottom of the tub wall and faucet.

3-2. Cleaning method. Use soft cloth with neutral detergent or soap water.

3-3. Some attentions. It is strictly prohibited to use sharp objects or hard clean
tool friction bath, in order to avoid scratch the bath surface, away from open flame,
high temperature bulb, cigarette butts etc, so as not to burn the bath surface, Avoid
the use of the paint, varnish removal agent such as acetone and chloroform organic
volume, these organic volume may cause the bath surface to soften, dissolve or
crack.

3-4. Self curing. If there any cut or scratch because of careless. Please coated car
polish or metal polishing agent on the surface of the injured, with soft cloth to wipe
a few times more hard, if the scratch is deep, can use 1000# water sand paper
remove the scratched, and then use the above method to polished it get bright
surface.

4. Caution

4.1. Note the skid.

4.2. Children must use under adult guardianship. Invalid should use under the
professional help.
4.3. Drunk , patients high blood pressure or heart disease use with caution.if any
uncomfortable please come out immediately.

You might also like