Scribd
Upload
90 views22 pages

HVDC Lab File

This document summarizes 6 experiments conducted using Simulink models to study high voltage direct current (HVDC) converters. Each experiment aims to analyze different converter configurations like 6 pulse, 12 pulse, and active rectifiers by varying firing angles and loads. The experiments measure output voltages, currents, and power factor at different operating conditions. The results are presented through plots and tables generated from the Simulink simulations.

Uploaded by

UtkarshKumbhare
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
90 views22 pages

HVDC Lab File

This document summarizes 6 experiments conducted using Simulink models to study high voltage direct current (HVDC) converters. Each experiment aims to analyze different converter configurations like 6 pulse, 12 pulse, and active rectifiers by varying firing angles and loads. The experiments measure output voltages, currents, and power factor at different operating conditions. The results are presented through plots and tables generated from the Simulink simulations.

Uploaded by

UtkarshKumbhare
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 22

HVDC LAB

FILE
EXPERIMENT 1

AIM: To study six pulse converter using Simulink and estimate


various outputs at different firing angles.

APPARATUS REQUIRED: PC with MATLAB software.

Simulink Model
RESULTS
With R load. alpha=0

alpha=30
With RL load. alpha=0

With RL load. alpha=30


With R load. alpha=60
Effect of source inductance

With R load. alpha=0

With RL load. alpha=30


With RL load. alpha=60
EXPERIMENT 2

AIM: To study twelve pulse converter using Simulink and estimate


various outputs at different firing angles.

APPARATUS REQUIRED: PC with MATLAB software.

Simulink model
RESULTS
With alpha=0 R=10 ohm

With alpha=0 R=10 ohm L=1mH


With alpha = 15 R=10 Ohm

With alpha = 15 R=10 Ohm L=1mH


EXPERIMENT 3

AIM: To study cosine firing scheme for 6 pulse converter using


simulink.

APPARATUS REQUIRED: PC with MATLAB software.

Simulink model
RESULTS
Firing angle near 0

Firing angle near 30


Firing angle near 60

Firing angle near 90


EXPERIMENT 4

AIM: To establish a monopolar link using three phase thyristor


module and transmit power from one bridge to another.

APPARATUS REQUIRED: PC with MATLAB software.

Simulink model
RESULTS
Ignition delay angle =10 ,Ignition advance angle =170
Ignition delay angle =30 ,Ignition advance angle =150
Ignition delay angle =60 ,Ignition advance angle =150
Ignition delay angle =30 ,Ignition advance angle =120
EXPERIMENT 5

AIM: To implement AC to DC conversion(hvdc light) using active


rectifier phase system for maintaining constant DC across the DC
link irrespective of the DC bus loading condition.

APPARATUS REQUIRED: PC with MATLAB software.

Simulink model
RESULTS
EXPERIMENT 6

AIM: To establish a mono-polar link and calculate AC line voltage


p.f. at the rectifier end if the AC line voltage at the inverter end is
330kV, load is 500MW and p.f. is 0.78 at the inverter end using m
file in MATLAB.(Rlink=3 Lline=1mH =15)

APPARATUS REQUIRED: PC with MATLAB software.

Matlab Code
Program Output For Given Values

You might also like