Scribd
Upload
32 views

Lesson 2 Part Detailing and Modifying

This document provides objectives and instructions for Lesson 2 on part detailing and modifying. The lesson will teach how to detail an existing model by adding features like holes, fillets, and chamfers. It provides step-by-step instructions on how to use extrude and fillet/chamfer tools to add a 25mm diameter hole with a 10mm depth, 10mm radius fillets on four edges, and 3mm 45 degree chamfers on selected edges. It includes images showing the process and the final modified part.

Uploaded by

hidayatullah
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
32 views

Lesson 2 Part Detailing and Modifying

This document provides objectives and instructions for Lesson 2 on part detailing and modifying. The lesson will teach how to detail an existing model by adding features like holes, fillets, and chamfers. It provides step-by-step instructions on how to use extrude and fillet/chamfer tools to add a 25mm diameter hole with a 10mm depth, 10mm radius fillets on four edges, and 3mm 45 degree chamfers on selected edges. It includes images showing the process and the final modified part.

Uploaded by

hidayatullah
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

LESSON 2

PART DETAILING AND


MODIFYING

Objectives of LESSON 2:

1. Detail up existing model by Extrude boss and/or extrude cut a part


2. Create fillets and/or chamfers on sharp edges of the part

Prepared by NCM-2012 Page 1


Part Detailing
1. In this lesson, part created in lesson 1 will be detailed up with; (1) hole, (2) fillet
and (3) chamfer. The isometric views and orthographic views are shown below.

2. Open folder BLOCK A.


3. (1) To create hole - Select Circle on Sketch toolbar, then a reminder to select a
plane will appear. Select the correct plane to position the circle. The selected
plane will be highlighted. If the highlighted plane is correct, click on that plane
and start sketch a circle roughly. At any position on the plane, without
determining required diameter yet.

Prepared by NCM-2012 Page 2


4. Using Smart dimension ( ), modify the desired diameter of the hole (dia-
25mm), and correct position of the hole on the plane. As shown below.

5. Select Extrude cut on the feature toolbar. Make sure the circle is highlighted.
Select blind, with minimum depth is 10 mm. A greater number can be key in.
Or, select through all, since the hole is cut through the whole thickness of the
block.

Prepared by NCM-2012 Page 3


6. Click or press enter. The extrude-cut of the block will be generated.

7. (2) To create fillet. Click Fillet tool on the feature toolbar. Select all four edges to
be filleted. To select more than one, press Ctrl and click on the edges. Each time
sharp edge selected, the list will appear at the items to fillet block. Radius of the
fillet is 10 mm. Then, click or press enter.

8. (3) To create chamfer. Click Chamfer tool on the feature toolbar. Select edges to
be chamfered similar procedure to create fillet. Parameter of chamfer are
distance =3mm, angle=45 degree. Then, click or press enter.

9. Exercise 2:

Prepared by NCM-2012 Page 4


Exercise 2:
Modify 3D model from Exercise in Lesson 1. The orthographic view of the model is
shown below:

ANSWER:

Prepared by NCM-2012 Page 5

You might also like