16bis0091 VL2017181003417 Ast03
16bis0091 VL2017181003417 Ast03
16bis0091 VL2017181003417 Ast03
K S SOMESH
Task 5
Problem statement:
Design a thermocouple based temperature measurement circuit to convert 0C to 50C into 0 -
5V. If the temperature exceeds 60C then a LED alarm should glow. Build the circuit using NI
ELVIS board. Test the performance of the circuit. Make measurements to complete the
following table.
Design:
Rf=1kohm
Rg=1kohm
Therefore A=Vout/Vd
A=5000/22.5
A=250
Therefore
R2/R1=222.22
R1=1Mohm
R2=222.22/3Mhm=74Mohm
Theoretical(V) Measured(V)
1 100 2.18
4.1 1.025
2 200 3.089
8.2 2.05
3 300 3.999
12.3 3.07
4 400 4.908
16.4 4.1
5 500 5.817
20.5 5.1
6 550 6.261
22.5 5.6
Task 6
An J type thermocouple is to be used in the measurement system which must provide an output
of 2V at 200C. A solid state temperature sensor system will be used to provide a reference
temperature correction. Temperature sensor has three terminals: supply, output voltage and
ground and the output varies as 8mV/ C. Sensitivity of K-type thermocouple is 50V/C at
200C. Build the circuit in Multisim and simulate the circuit to make measurements and
complete the following table.
VCC
10V VEE
U1 R1 -10V
7
5
1
3 100k
6
2
R6
4
U3
VEE 741 R2
4
995k 2
V1 -10V 100k 6
R3
10mV R5 3
10k 100k
7
5
1
R7 741
VEE
V3 R4
-10V 995k 100k XMM1
100uV
4
U2
VCC
2
10V
6
VCC 741
7
5
1
10V
Sensitivity=50Uv/c
Temp=0->200
o/p=2V max
V=50(T-0)
=50*200
=10Mv