Manual Supplement: © 2013-2015 Fluke Corporation. All Rights Reserved

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Manual Supplement

Manual Title: 5080A Operators Supplement Issue: 2


Print Date: July 2012 Issue Date: 6/15
Revision/Date: Page Count: 1

This supplement contains information necessary to ensure the accuracy of the above manual.
This manual is distributed as an electronic manual on the following CD-ROM:

CD Title: 5080A
CD Rev. & Date: 3, 11/2011
CD PN: 3502934

2013-2015 Fluke Corporation. All rights reserved.

5080A Operators Manual Supplement

Change #1, 64917, 397


On page 1-3, under Safety Information, delete the first sentence and all
the bullets.
On page 1-4, under the Symbols table, delete the CAT I information and
add the following:

Conforms to relevant South Korean EMC Standards.

On page 1-7, under General Specifications, replace the Safety and


EMC sections:
Safety ......................................... IEC 61010-1: Overvoltage category II, Pollution Degree 2
Electromagnetic Compatibility (EMC)
International ............................... IEC 61326-1: Basic Electromagnetic Environment
CISPR 11: Group 1, Class A
Group 1: Equipment has intentionally generated and/or uses
conductively-coupled radio frequency energy that is necessary for
the internal function of the equipment itself.
Class A: Equipment is suitable for use in all establishments other
than domestic and those directly connected to a low-voltage power
supply network that supplies buildings used for domestic purposes.
There may be potential difficulties in ensuring electromagnetic
compatibility in other environments due to conducted and radiated
disturbances.
Emissions that exceed the levels required by CISPR 11 can occur
when the equipment is connected to a test object.
Korea (KCC) .............................. Class A Equipment (Industrial Broadcasting & Communication
Equipment)
Class A: Equipment meets requirements for industrial
electromagnetic wave equipment and the seller or user should take
notice of it. This equipment is intended for use in business
environments and not to be used in homes.
USA (FCC) ................................. 47 CFR 15 subpart B. This product is considered an exempt device
per clause 15.103.
On page 1-9, in the Resistance table, add note [5] to the table head of the Full Specs
Load and the Max Peak Current columns and add note 5.
[5] Imax and Max Peak Current are limited to 150 mA for the 0 to 19 resistors in COMP 2-wire
mode.

6/15 1

You might also like