P770 Software Upgrade Guide 1 Chapter One Hardware and Software Prepared Before Upgrade 2
P770 Software Upgrade Guide 1 Chapter One Hardware and Software Prepared Before Upgrade 2
P770 Software Upgrade Guide 1 Chapter One Hardware and Software Prepared Before Upgrade 2
Update Data Cable Name GB 5pin-USB Data Cable Update Data Cable No 31-028916
Driver InstalledIf smart phone is used first time, you need install the driver:
(1)Pull out battery of the smart phone and connect to PC, then PC will be as shown below
step1
step2
step3
3Select Open, appear the following interface, then check DA DL All With Check Sum & USB
Mode & DA Download All
4Firstly click the button Firmware Upgrade, then pull out the battery of the smart phone, insert
the USB data cable into the PC, start to download automatically
Upgrade is complete, please boot up the smart phone to test, to confirm whether the software
download successfully. The check procedures are as follows:
1Boot up phone test
After upgrade, please pull out battery firstly, then install battery, press the power button to boot up the
phone, the phone should be able to boot up normally.
2Check the software version:
Enter ####0000#, view the version of the smart phone software, the version of the software should be
the downloadable version.
3Query the smart phone serial number and IMEI number:
Enter ####2222# and *#06#,view serial number and IMEI numberthese two numbers should stay
the same as the back of the smart phone.
4Clear user data:
Enter ####7777#, restore the factory settings, clear the user data, the smart phone will shut down
automatically after clearing data.