Scribd
Upload
1K views1 page

EP Booster Manual

The EP-Booster is a discrete FET preamp that provides up to +20db of boost with shimmering highs and lows. It has internal DIP switches to select the boost level and EQ setting. The preamp can run on a 9V battery or external 9-18V power supply. It has inputs and outputs along with controls for gain, power, and DIP switch settings.

Uploaded by

JP Pretorius
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

EP Booster Manual

The EP-Booster is a discrete FET preamp that provides up to +20db of boost with shimmering highs and lows. It has internal DIP switches to select the boost level and EQ setting. The preamp can run on a 9V battery or external 9-18V power supply. It has inputs and outputs along with controls for gain, power, and DIP switch settings.

Uploaded by

JP Pretorius
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Discrete Pre-amp

Congratulations on purchasing the Xotic EP-Booster!! The EP-Booster is a discrete FET preamp with low
impedance output providing up to +20db of unadulterated boost thats multi-dimensional with shimmering
highs and lows. The internal DIP switches let you choose the boost level and EQ setting.
The EP-Booster can be powered by 9-volt up to 18-volts for desired headroom.

DC Jack
2.1mm x 5.5mm
9 to 18vdc -negative center

Gain control knob when an external power supply is


*default setting: used,the battery is disconnected
minimum=+3db gain from the circuit

remove four screws from the


bottom plate to access battery
On/Off status led
IN

Input Jack
(nominal input -20db)

Output Jack Unplug when its not in use


OUT

for a longer battery life

+ Internal DIP switch settings

On/Off switch
(True Bypass)

Specs: default settings


ON
Dimensions (W/D/H): 3.5" x 1.5" x 1.5" 1 +3db gain - on
ON

(89mm X 38mm X 38mm) 2 bright switch - on (flat eq)


1 2
Weight: 0.57 lbs. (260g)
True Bypass Switching unity gain settings
Power Consumption: 9VDC/5mA ON
1 +3db gain - off
Battery Type: 9VDC (006P) x 1 2 bright switch - on (flat eq)
1 2
AC Adapter (Optional): 9VDC-18VDC
Negative Tips (Regulated only)
vintage settings
Input Impedance: 1M ohm
ON
Output Impedance: 1K ohm (min.) / variable 1 +3db gain - off
2 bright switch - off
1 2
Inside view
1 of 1

You might also like