Scribd
Upload
317 views2 pages

Guidelines For Assignment Report Content

The document provides guidelines for preparing an assignment report, which is worth 50% of the total marks. It specifies the required sections of the report, including an introduction, design procedure, discussion and conclusion, and references. The design procedure section must be over 5 pages and include details on the design requirements, analysis, simulation results, test results, and final design.

Uploaded by

Shashini Maldeniya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
317 views2 pages

Guidelines For Assignment Report Content

The document provides guidelines for preparing an assignment report, which is worth 50% of the total marks. It specifies the required sections of the report, including an introduction, design procedure, discussion and conclusion, and references. The design procedure section must be over 5 pages and include details on the design requirements, analysis, simulation results, test results, and final design.

Uploaded by

Shashini Maldeniya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Assignment Report Content

Follow the guidelines given in this document when you are preparing the report. Use the template
uploaded in the Courseweb and make sure that you follow the styles in it.

The report will carry 50% of the total marks.

Introduction (about 1 page)


Explain the design scope (you may include information given in the assignment document)

Design Procedure (more than 5 pages)


1. Design requirements
2. Data references
Include the data obtained from the sources you referred.
3. Analysis steps (more than 1 page)
Bias point analysis (mention about the inputs and outputs used)
ac analysis (mention about the inputs and outputs used)
*include the calculations
4. Simulation results (more than 1 page)
Inputs and outputs used
Bias point analysis; include the voltage measurements, waveforms and schematic
of the circuit
ac response; ac gain, frequency response, schematic of the circuit
5. Test Results (more than 1 page)
Explain the experimental procedure
Inputs and outputs used
Equipment used (any special modes, if used)
Bias point analysis; include the voltage measurements, waveforms and images of
tested circuit
ac response; ac gain, frequency response, images of tested circuit
*use ac analysis to prove the gain you obtained during the testing.
6. Final design (more than 1 page)
Include details and images of the finalized design

Discussion and Conclusion (more than 1 page)


1. Reflection on your work
2. Issues faced during the designing (theoretical calculations, simulation, implementing and
testing)

References
Citations and references should be in IEEE format.

Appendix

You might also like