Scribd
Upload
420 views2 pages

Transfer Slab Design

This document provides steps for transfer slab design using wall select to prepare analysis input files. The steps are: 1) Export wall forces from ETABS under 6 load cases and replace in the wall select input file. 2) Prepare a FULLWTP.txt file with pier names, levels, bottom points, start and end points. 3) Export the transfer level from ETABS to SAFE as an F2K file. 4) Run wall select using the created F2K file as input for SAFE analysis.

Uploaded by

Tan Xian Hui
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
420 views2 pages

Transfer Slab Design

This document provides steps for transfer slab design using wall select to prepare analysis input files. The steps are: 1) Export wall forces from ETABS under 6 load cases and replace in the wall select input file. 2) Prepare a FULLWTP.txt file with pier names, levels, bottom points, start and end points. 3) Export the transfer level from ETABS to SAFE as an F2K file. 4) Run wall select using the created F2K file as input for SAFE analysis.

Uploaded by

Tan Xian Hui
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Transfer Slab design (with using wall select to prepare analysis input file)

1. Prepare input file for wall select as wall design. Export wall forces from ETABs with 6 basic load
cases: DL, LL, NLX, NLY, WLPX, WLPY. Replace this PIER.txt into previous wall select input file.

2. Prepare FULLWTP.txt which contain Pier name, Level, Bot, Start point and End point, example
and sketch as below:-
3. Export Transfer level from ETAB to SAFE (F2K file).
4. Run wall select and use the created F2K file for SAFE input.

You might also like