Expenditure
Expenditure
Expenditure
DR CR
Purchases 6,800.0
Accounts Payable 0
6,800.0
Control
0
Vouchers Payable System
Rather than using the AP procedures described in the previous section, many
firms use a vouchers pay- able system. Under this system, the AP department uses
cash disbursement vouchers and maintains a voucher register. After the AP clerk
performs the three-way match, he or she prepares a cash disburse- ment
voucher to approve payment. Vouchers provide improved control over cash
disbursements and allow firms to consolidate several payments to the same
supplier on a single voucher, thus reducing the number of checks written. Figure
5-8 shows an example of a voucher.
Each voucher is recorded in the voucher register, as illustrated in Figure 5-9. The
voucher register reflects the AP liability of the firm. The sum of the unpaid vouchers
in the register (those with no check numbers and paid dates) is the firms total AP
balance. The AP clerk files the cash disbursement voucher, along with supporting
source documents, in the vouchers payable file. This file is equivalent to the open
AP file discussed earlier and also is organized by due date. The DFD in Figure 5-1
illustrates both liabil- ity recognition methods.
4. What are the three logical steps of the cash dis- bursements system?
VOUCHER CASH
PACKET DISBURSEMENT
A/P
DR CR
Accounts Payable XXXX.XX
Cash
XXXX.XX
UPDATE AP RECORD. Upon receipt of the voucher packet, the AP clerk removes
the liability by deb- iting the AP subsidiary account or by recording the check
number and payment date in the voucher regis- ter. The voucher packet is filed
in the closed voucher file , and an account summary is prepared and sent to the
general ledger function.
POST TO GENERAL LEDGER. The general ledger function receives the journal voucher
from cash disbursements and the account summary from AP. The voucher shows the
total reductions in the firms obligations and cash account as a result of payments
to suppliers. These numbers are reconciled with the AP summary, and the AP
control and cash accounts in the general ledger are updated accordingly. The
approved journal voucher is then filed. This concludes the cash disbursements
procedures.
5. What general ledger journal entries does the pur- chases system trigger? From which departments do these
journal entries arise?
6. What two types of exposures can close supervi- sion of the receiving department reduce?
Supervision
In the expenditure cycle, the receiving department is the area that most benefits from
supervision. Large quan- tities of valuable assets flow through this area on their way to
the warehouse. Close supervision here reduces the chances of two types of exposure: (1)
failure to properly inspect the assets and (2) the theft of assets.
7. How can a manual purchases cash disbursements system be reengineered to reduce discrepancies, be more
accurate, and reduce processing costs?
The automated system described in the previous section simply replicates many of the
procedures in a manual system. In particular, the AP task of reconciling supporting
documents with supplier invoices is labor-intensive and costly. The following example
shows how reengineering this activity can produce considerable savings.
The Ford Motor Company employed more than 500 clerks in its North American AP
department. Analysis of the function showed that a large part of the clerks time was
devoted to reconciling discrepan- cies among supplier invoices, receiving reports, and
POs. The first step in solving the problem was to change the business environment.
Ford initiated trading partner agreements with suppliers in which they agreed in
advance to terms of trade such as price, quantities to be shipped, discounts, and lead
times. With these sources of discrepancy eliminated, Ford reengineered the work flow
to take advantage of the new environment. The flowchart in Figure 5-17 depicts the key
features of a reengineered system.
Data Processing
The following tasks are performed automatically.
1. The inventory file is searched for items that have fallen to their reorder points.
2. A record is entered in the purchase requisition file for each item to be replenished.
3. Requisitions are consolidated according to vendor number.
4. Vendor mailing information is retrieved from the valid vendor file.
5. Purchase orders are prepared and added to the open PO file.
6. A transaction listing of POs is sent to the purchasing department for review.
Receiving Department
When the goods arrive, the receiving clerk accesses the open PO file in real time by
entering the PO num- ber taken from the packing slip. The receiving screen, illustrated
in Figure 5-18, then prompts the clerk to enter the quantities received for each item on
the PO.
Data Processing
The following tasks are performed automatically by the system.
1. Quantities of items received are matched against the open PO record, and a Y
value is placed in a logical field to indicate the receipt of inventories.
2. A record is added to the receiving report file.
3. The inventory subsidiary records are updated to reflect the receipt of the inventory items.
4. The general ledger inventory control account is updated.
5. The record is removed from the open PO file and added to the open AP file, and
a due date for pay- ment is established.
Each day, the DUE DATE fields of the AP records are scanned for items due to be
paid. The following procedures are performed for the selected items.
1. Checks are automatically printed, signed, and distributed to the mail room for
mailing to vendors. EDI vendors receive payment by electronic funds transfer
(EFT). EFT is discussed in the appendix to Chapter 12.
2. The payments are recorded in the check register file.
3. Items paid are transferred from the open AP file to the closed AP file.
4. The general ledger AP and cash accounts are updated.
5. Reports detailing these transactions are transmitted via terminal to the AP and
cash disbursements departments for management review and filing.
Because the financial information about purchases is known in advance from the
trading partner agree- ment, the vendors invoice provides no critical information that
cannot be derived from the receive
report. By eliminating this source of potential discrepancy, Ford was able to eliminate the task of
recon- ciling vendor invoices with the supporting documents for the majority of purchase
transactions. As a result of its reengineering effort, Ford was able to reduce its AP staff from 500
to 125.
8. What steps of independent verification does the general ledger department perform?
Discussion Questions
1. What three documents must accompany the pay- ment of an invoice? Discuss where these three documents
originate and the resulting control implications.
2. Are any time lags in recording economic events typically experienced in cash disbursements sys- tems? If so,
what are they? Discuss the accounting professions view on this matter as it pertains to fi- nancial reporting.
3. Discuss the importance of supervision controls in the receiving department and the reasons behind blind fields
on the receiving report, such as quan- tity and price.
4. Why do the inventory control and general ledger departments seem to disappear in computer-based
purchasing systems (Figure 5-14)? Are these func- tions no longer important enough to have their own
departments?
5. How does the procedure for determining inventory requirements differ between a basic batch-process- ing system
and batch processing with real-time data input of sales and receipts of inventory? What about for the
procedures the receiving department uses?
6. What advantages are achieved in choosing
a. a basic batch computer system over a manual system?
b. a batch system with real-time data input over a basic batch system?
7. Discuss the major control implications of batch systems with real-time data input. What compen- sating
procedures are available?
8. Discuss some specific examples in which informa- tion systems can reduce time lags and how the firm is
positively affected by such time lags.
9. You are conducting an end-of-year audit. Assume that the terms of trade between a buyer and a seller are
free on board (FOB) destination. What document provides evidence that a liability exists and may be
unrecorded?
10. Describe a three-way match.
1. Which document is used by cost accounting to allocate direct labor charges to work-in-process?
After cost accounting allocates labor costs to the WIP accounts, the charges are summarized
in a labor distribution summary and forwarded to the general ledger function.
Discussion Questions
1. What is the importance of the job ticket? Illustrate the flow of this document and its information from inception
to impact on the financial statements.
2. Are any time lags in recording economic events typically experienced in payroll systems? If so, what are they?
Discuss the accounting professions view on this matter as it pertains to financial reporting.
3. What advantages are achieved in choosing a basic batch computer system over a manual system? What
advantages are achieved in choosing a batch system with real-time data input over a basic batch system?
4. Discuss the major control implications of batch systems with real-time data input. What compen- sating
procedures are available?
5. Discuss some specific examples in which informa- tion systems can reduce time lags and how the firm is
positively affected by such time lags.
6. Discuss some service industries that may require their workers to use job tickets.
290 P A R T II Transaction Cycles and Business Processes
7. Payroll is often used as a good example of when batch processing by using magnetic tapes is consid- ered
appropriate. Why is payroll typically considered a good application for this type of storage device?
8. If an asset that is not fully depreciated is sold or disposed, but the fixed asset records are not adjusted, what
effect will this have on the financial statements?
9. Discuss the fundamental risk and control issues associated with fixed assets that are different from raw
materials and finished goods.
10. Describe an internal control that would prevent an employee from removing a computer and then reporting
it as scrapped.
290 P A R T II Transaction Cycles and Business Processes
11. Describe an internal control that would prevent the payment of insurance premiums on an auto- mobile
the company no longer owns.
12. Describe an internal control that would prevent the charging of depreciation expense to the main- tenance
department for a sweeper that is now located in and used by the engineering depart- ment.
13. Describe an internal control that would prevent the acquisition of office equipment that the firm does not
need.
14. What negative consequences result when fixed asset records include assets that the firm no lon- ger owns?
290 P A R T II Transaction Cycles and Business Processes