Technical Service Information: BMW ZF-5HP-18

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

BACK

BACK
Technical Service Information

BMW ZF-5HP-18
"BIND-UP" WITH SELECTOR IN
MANUAL "2" POSITION, 1st GEAR

COMPLAINT: Before or after overhaul, vehicles equipped with ZF-5HP-18, may exhibit a "Bind-Up"
condition in the Manual "2" position, 1st gear.

CAUSE: The cause may be, the plastic "D" Clutch One-way Check Valve assembly located in the
Lower Rear valve body, shown in Figure 2, may be broken allowing the "B" Clutch (Reverse
Input Clutch) to be on while the "D" Clutch (Low/Reverse Clutch) is on in 1st gear.

CORRECTION: Replace the "D" Clutch One-way Check Valve assembly , as shown in Figure 1, with a new
assembly from ZF, or a new "Aluminum" check valve assembly offered by:
Mario Aristides. Phone (305) 666-3544 or Fax (305) 666-8238.

"D" CLUTCH ONE-WAY CHECK VALVE ASSEMBLY

"Original"
PLASTIC CHECK VALVE
ZF Number 1043-226-028

"Replacement"
ALLUMINUM CHECK VALVE

Copyright 2001 ATSG


Figure 1
01-34
AUTOMATIC TRANSMISSION SERVICE GROUP Page 1 of 2
BACK
BACK
Technical Service Information
LOWER REAR VALVE BODY

31 6 42
.52 7 0
10
02 98
5
.00
F1

1-
2
10
56
42
70
53 90
0

10 12
11 14

13
18
15 * 16
17
20

21
19
22

10. "G" Clutch Damper Valve


11. 3-2 Traction Valve
12. 2-3 Traction Valve
13. "D" Clutch Accumulator Regulator Valve
14. "D" Clutch Damper Valve
* 15. "D" Clutch One-Way Check Valve Assembly
16. Reverse Lock-Out Valve
17. "F" Clutch Accumulator Regulator Valve
18. "F" Clutch Damper Valve
19. Shift Valve Number 2
20. Pressure Reduction Valve For MV 1 thru MV 6
21. Traction Coast Valve Number 2
22. Traction Coast Valve Number 1
Copyright 2001 ATSG
Figure 2
01-34
AUTOMATIC TRANSMISSION SERVICE GROUP Page 2 of 2

You might also like