Structural TieDown Strap
Structural TieDown Strap
Structural TieDown Strap
Structural
TieDown strap
St r u c t u r a l Ti e D o w n St r a p
THE VERSATILE
TIE DOWN SYSTEM
APPLICATION:
Structural TieDown Strap is suitable for use where
overlaying members.
USES SPECIFICATIONS:
Structural TieDown Strap is
a fast and effective method for Steel Grade G300
joining timber wall plates to
studs, timber rafters to wall
Thickness
plates and timber battens (Total Coated)
0.8 mm
to rafters.
ADVANTAGES Galvanized
Coating
Z275
Easy to use.
MiTek 30 x 2.8mm
Versatile, can be cut to length
Nails galvanized
for each application. reinforced head.
Economical.
2
St r u c t u r a l Ti e D o w n St r a p - Lo a d Data
COMPLIANCE
AS1684 Residential Timber Framed Construction.
3
St r u c t u r a l Ti e D o w n St r a p - In s ta l l at i o n
1. Structural TieDown Strap, to be effective, should be pulled If the ends cannot be wrapped around supporting member,
tight before fixing the loose end. To minimise the number the number of MiTek nails required will depend on the load to be
of nails required, and to develop the full design load of carried and the timber being used.
Structural TieDown Strap, ends should be wrapped around
See Figure 2. In this case refer to AS1684 Residential Timber
supporting members.
Framed Construction. As a guide, 10 MiTek nails each end are
See Figure 1. In this case four MiTek 30 x 2.8mm galvanized required to develop the full strength of Structural TieDown Strap
reinforced head nails located as shown are required. under wind loading.
1 MiTek nail
Stud
For more information about MiTeks Engineered Building Products or any other MiTek products or your nearest
licensed MiTek fabricator, please call your local state office or visit: mitek.com.au
TD 08/15
VIC (03) 8795 8888 NSW (02) 8525 8000 QLD (07) 3861 2100 SA (08) 8234 1326 WA (08) 9412 3534 New Zealand (09) 274 7109