HiPosPlus BOMT09 INNO - 8-2008NEU PDF
HiPosPlus BOMT09 INNO - 8-2008NEU PDF
HiPosPlus BOMT09 INNO - 8-2008NEU PDF
For tightening the insert screw please always use a torque driver with 1,1 Nm. We recommend our driver
DTN011S with Torx 8-bit DS-T08TB.
The insert enables a max. cutting depth of ap = 9 mm and is perfectly qualified for ramping.
Order-No.: 7850???
INNOTOOL
Florianstrae 17 71665 Vaihingen-Horrheim Germany
Phone: +49-(0)7042-8316-0 Fax: +49-(0)7042-8316-26
E-mail: [email protected]
cutter dia. ramping C min~ max ap/rev C min_ max ap/rev C max_ max ap/rev
[mm] angle [mm] [mm] [mm] [mm] [mm] [mm]
12 10,0 16 2,2 21,2 5,0 23 6,0
15 11,0 18 1,8 26,8 7,2 29 8,5
16 10,0 20 2,2 28,8 7,0 31 8,3
20 7,0 28 3,0 36,7 6,4 39 7,3
25 4,4 38 3,1 46,7 5,2 49 5,8
28 3,7 44 3,2 52,7 5,0 55 5,4
32 2,8 52 3,0 60,7 4,4 63 4,7
40 2,4 68 3,6 76,7 4,8 79 5,1
50 1,3 88 2,7 96,7 3,3 99 3,4
63 1,0 114 2,7 122,7 3,2 125 3,3
C min~ : smallest possible diameter with uneven ground resp. through hole.
C min_ : smallest possible diameter with even ground resp. blind hole.
C max_ : largest possible diameter with even ground resp. blind hole.