Scribd
Upload
51 views8 pages

Configuration Guide Lines in New Modems: Guidelines To Install USB Driver

This document provides configuration guidelines for a T-KD 318-EUI modem with firmware version R1.00B02.3AS.BL. It outlines the IP addresses for the Ethernet and USB ports, how to configure the TCP/IP settings on a computer to connect to the modem via either port, and how to install the necessary USB driver. It also provides instructions for configuring the modem in PPPoE or bridge mode and saving the configuration.

Uploaded by

Ranjith Kumar Goud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
51 views8 pages

Configuration Guide Lines in New Modems: Guidelines To Install USB Driver

This document provides configuration guidelines for a T-KD 318-EUI modem with firmware version R1.00B02.3AS.BL. It outlines the IP addresses for the Ethernet and USB ports, how to configure the TCP/IP settings on a computer to connect to the modem via either port, and how to install the necessary USB driver. It also provides instructions for configuring the modem in PPPoE or bridge mode and saving the configuration.

Uploaded by

Ranjith Kumar Goud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

Configuration Guide Lines in New Modems

(Model NO.: T-KD 318-EUI)


(Current Firmware Version : R1.00B02.3AS.BL)

1. IP addresses of CPE: a) On Ethernet Port: 192.168.1.1


b) On USB Port : 192.168.1.2

i.e. Two IP addresses are allotted to ADSL Router(CPE), Hence IP address


to be configured to computer (TCP/IP properties) will be:

From: 192.168.1.3 To: 192.168.1.34

2. TCP/IP properties setting on computer.

a) Obtain IP address automatically. It will OK.


b) If you want to assign IP address to Compter manually then:

IP address: 192.168.1.3

Subnet Mask: 255.255.255.0

Default Gateway: 192.168.1.1 . For Ethernet Port


Or 192.168.1.2 ... For USB Port

Guidelines to install USB Driver:-


1. First start installing USB Driver.
2. During the installation process, you will be asked to connect the
ADSL Router Through USB port.
3. Than connect the Router Physically to your
Computer/Laptop
TCP/IP properties Setting:
CASE I
Abtain IP address Automatically:
CASE II: Use the following IP addresses.

TCP/IP Properties Setting for USB:


TCP/IP Properties Setting for Ethernet:

CPE configuration in PPPoE Mode


Parameters Existing Settings Required Settings
Connection Type PPPoA VC Mux PPPoE LLC
Default Route Disabled Enabled
NAT Disabled Enabled

CPE configuration in Bridge Mode:


Command to Save the configuration
Tools -> Misc -> Save & Reboot, as shown below

Setting in Firewall:

You might also like