DeviceNET Scanner Error Codes Page 1 of 3

+ ), )

I am getting this Error Code through DeviceNET, what does it mean?

The scanner module has a numeric display that indicates diagnostic

information. It flashes at approximately one second intervals if more than
one code must be shown. Numbers below 64 are node numbers, higher
numbers are error or status codes. Most status codes apply to one or more
! devices in the . This is shown by flashing the code and the node number
alternately. If many codes and node numbers must be shown, the display
" #"$#%""& "$'% cycles through them in node number order.

The following table describes the codes. The colors have these meanings:
" #%"#%"" " ' (

Green shows normal conditions, or abnormal conditions caused by user

) * action.
Blue shows abnormal or error conditions.
Red shows severe errors, possibly requiring a replacement scanner.
Bold codes show the most common conditions.

"Scanner" means the scanner module showing the display, except in a few
cases where another scanner is explicitly referenced (see codes 83, 87,
88).

"Device" means some other node on the network, typically a slave device
in the scanner's scanlist. This can be another scanner's slave-mode
personality (see code 86).

- . + / 0. 1,/ - * / /
!"
2 .3
4 + - / 0 / / 5
( / . ,/ / 0 / 4 0 2 .
&"
*
.
0 . 40 *
&$
0 .
+ -- - / 4*
0. 1 / 0 .
#$ & 4
/
.3
+ / 6 4* / / /
*1 5 7 . / /
#"
- 5- *- 5 / / *
3 . 40 .
+ - / 40 4 .
&8
. / 44 .
44 / .
#% 7 .1 4
.3
44 4 .
#! .1
4
/ / 44 .3
+ 2 9 40 4 /
##
/ . 9 .
+ 7 ( / / 5
5 / 4 /7 *.
#&
- 2 * &%.
4 &%.
4 / /

http://rockwellautomation.custhelp.com/cgi-bin/rockwellautomation.cfg/php/enduser/prnt... 07/12/2008
DeviceNET Scanner Error Codes Page 2 of 3

0 5 * - /
#' / 1 - : -3. / . / 4
7 . 6 4* 7 .
; / - + <) ; 7
&
. 0 . < ; .
; / - / < - 0
$
=(; <, . 0 .
) > 4 / 40 .
% 4 0 #? 0
4 .
+ 0 / *@ * - 4*
- / 1 7 5- 5 3
- 9 -- 7* .+ *7
. / 2 . /
40 . 7 .
9 0 . ,/ /
&(
/ . 9 - .
+ 9 0 / % 40 4 9 .
7* .
+ 2 - 9 40 4 4 9 . -
/ 0 4 9 . 4 * .
+ - 09 / 40 .
0 / 1 + <) 3 ,/ 4 /
/ / ; 5 + <)
. 1 "3.
/ - '+ / - *
& 7* - * 40 .
.
/ - ' * / / / 0 2
/ / 7
> 7* / 4- * 2.
.
+ - * - : - .
.
(+ . ,/ + / 40 7 (+ 4
-- ( :+ / .
A
*
40 - - *.
; / 7 / < - 0
A"
- . 0 .
B : 44 / +
+ - . -/* 0 *. / *
') 0 4 4 / - 7
. 4 4 . /
4 4 07 .
- - . /
'$ + - . - 7 - 0 -
+ - .
=<( C - - 0 . .+ /
A
=<( C - - 0 .
; / / . / - 0
A&
0 .
; 7 4 - * .
A
4 .
; 7 / - * .
AA
4 .
)% ( , = . # - .
< + 0 =<( C # - .
)8
; -0 .
) B . # - .
; / 4 / $&8&: + / 0 *
)A
. - + .

DISCLAIMER
This knowledge base web site is intended to provide general technical
information on a particular subject or subjects and is not an exhaustive
treatment of such subjects. Accordingly, the information in this web site is

http://rockwellautomation.custhelp.com/cgi-bin/rockwellautomation.cfg/php/enduser/prnt... 07/12/2008
DeviceNET Scanner Error Codes Page 3 of 3

not intended to constitute application, design, software or other

professional engineering advice or services. Before making any decision
or taking any action, which might affect your equipment, you should
consult a qualified professional advisor.

ROCKWELL AUTOMATION DOES NOT WARRANT THE

COMPLETENESS, TIMELINESS OR ACCURACY OF ANY OF THE
DATA CONTAINED IN THIS WEB SITE AND MAY MAKE CHANGES
THERETO AT ANY TIME IN ITS SOLE DISCRETION WITHOUT NOTICE.
FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO
USERS "AS IS." IN NO EVENT SHALL ROCKWELL BE LIABLE FOR
ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT,
INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT OR DAMAGE, EVEN IF
ROCKWELL AUTOMATION HAVE BEEN ADVISED ON THE
POSSIBILITY OF SUCH DAMAGES.

ROCKWELL AUTOMATION DISCLAIMS ALL WARRANTIES WHETHER

EXPRESSED OR IMPLIED IN RESPECT OF THE INFORMATION
(INCLUDING SOFTWARE) PROVIDED HEREBY, INCLUDING THE
IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE,
MERCHANTABILITY, AND NON-INFRINGEMENT. Note that certain
jurisdictions do not countenance the exclusion of implied warranties; thus,
this disclaimer may not apply to you.

Copyright 2006-2008 Rockwell Automation. All rights reserved.

http://rockwellautomation.custhelp.com/cgi-bin/rockwellautomation.cfg/php/enduser/prnt... 07/12/2008