Scribd
Upload
29 views1 page

Solution For Code Congestion: Then We Can Monitor The Counters As Follows To Check The Effect of LDR Action

Code congestion occurs when there are too many codes allocated in a cell, resulting in low call success rates for circuit-switched and packet-switched services. Counters can be checked to detect code congestion issues, including rejected RRC connections and failed RAB establishments due to congestion. To address code congestion, expanding to two carriers is recommended for severely congested single carrier cells. Enabling the LDR algorithm is also suggested, which can adjust codes and reduce bit rates to alleviate congestion, as monitored through additional counters.

Uploaded by

samtec32
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
29 views1 page

Solution For Code Congestion: Then We Can Monitor The Counters As Follows To Check The Effect of LDR Action

Code congestion occurs when there are too many codes allocated in a cell, resulting in low call success rates for circuit-switched and packet-switched services. Counters can be checked to detect code congestion issues, including rejected RRC connections and failed RAB establishments due to congestion. To address code congestion, expanding to two carriers is recommended for severely congested single carrier cells. Enabling the LDR algorithm is also suggested, which can adjust codes and reduce bit rates to alleviate congestion, as monitored through additional counters.

Uploaded by

samtec32
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Solution for code congestion

Summary
Code congestion will cause low CSSR of both CS and PS service.
We can check counters as below to find code congestion:
VS.RRC.Rej.Code.Cong+VS.RAB.FailEstCs.Code.Cong+VS.RAB.FailEstPs.Code.Cong+VS.RAC.SHO.Fail.O
VSF.Cong+VS.RAC.DCCC.Fail.OVSF.Cong+VS.RAC.HHO.CodeAssignRej.DL

Solution
Code congestion will happen in single carrier cell or F1 cell. If single carrier cell
experience very serious code congestion, expanding 2 carriers is recommended.
To solve code congestion, we recommend using LDR algorithm also. The MML
configuration is as follows:

Switch on the LDR switch:


MOD CELLALGOSWITCH: CellId=0, NBMLdcAlgoSwitch= CELL_CODE_LDR -1;

Setting LDR action:


MOD CELLLDR: CellId=0, DLLDRFIRSTACTION=CodeAdj, DLLDRSECONDACTION=BERateRed,
DlLdrBERateReductionRabNum=1, GoldUserLoadControlSwitch=ON;

Then we can monitor the counters as follows to check the effect of LDR action:
VS.LCC.LDR.BERateDL
VS.LCC.LDR.CodeAdj
VS.LCC.LDR.CodeAdj.Succ

2017-7-22 1 , 1

You might also like