100% found this document useful (1 vote)
632 views1 page

Procast Software Training-Jan 27, 2015

The document provides information about a ProCAST software training session on mould and die casting to be held from 27-29 January 2015 at the Computer Lab of the Faculty of Mechanical Engineering at Universiti Malaysia Pahang in Pekan, Pahang, Malaysia. The 3-day training will cover ProCAST topics including the user interface, simulation methodology, material properties, boundary conditions, thermal calculations, sand casting, virtual mold calculations, and HPDC calculations and modeling. The training fee is RM2700 and contacts are provided for further information.

Uploaded by

tabibkarim
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100% found this document useful (1 vote)
632 views1 page

Procast Software Training-Jan 27, 2015

The document provides information about a ProCAST software training session on mould and die casting to be held from 27-29 January 2015 at the Computer Lab of the Faculty of Mechanical Engineering at Universiti Malaysia Pahang in Pekan, Pahang, Malaysia. The 3-day training will cover ProCAST topics including the user interface, simulation methodology, material properties, boundary conditions, thermal calculations, sand casting, virtual mold calculations, and HPDC calculations and modeling. The training fee is RM2700 and contacts are provided for further information.

Uploaded by

tabibkarim
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PROCAST SOFTWARE TRAINING

(MOULD & DIE)

DATE

27-29 JAN 2015


VENUE

Computer Lab, Faculty of Mechanical Engineering


UNIVERSITI MALAYSIA PAHANG (UMP), PEKAN CAMPUS

FEE
RM2700
ProCAST introduction and module description

T
ProCAST graphics users interface
ProCAST simulation methodology CONTACTS US
Material Properties and Database
Boundary Conditions definitions AEC, UMP

O
Thermal Calculation
26600 Pekan
Getting Started
Introduction to VisualCAST Pahang
Gravity Sand Casting

P
Sand Casting +609 424 6344 (T)
Introduction and Concept
Basic Repair tools and Mesh Edition +609 424 6345 (F)
Visual Mesh examples [email protected] (E)

I Virtual Mold calculations


Model simplification and symmetry
Filters
Simulation Run Parameters and
aec.ump.edu.my (W)
SH NUR AQIDA

C TStep
Restart calculations
HPDC
+609 424 6280
SH IKHMAR AFZAN

S
Cycling calculations
HPDC Cycling +609 424 6289
HPDC Filling
HPDC inlet modeling
Air vents and gas model
ORGANISED BY
AUTOMOTIVE ENGINEERING CENTRE (AEC), UMP

You might also like