Scribd
Upload
37 views1 page

Feature

This document describes a groove coupler sensor module that features an imported groove coupler sensor, fixed bolt hole for installation, LM393 comparator, 5mm groove width, operates on 3.3-5V DC with 15mA current, and digital switching output. It can directly connect its DO output to a microcontroller port to detect speed or block detection. The DO output can also connect to relays, switches, buzzers. The module requires connection of VCC to 3.3-5V power, GND, DO output, and has an unused AO pin.

Uploaded by

Hassan Allawi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
37 views1 page

Feature

This document describes a groove coupler sensor module that features an imported groove coupler sensor, fixed bolt hole for installation, LM393 comparator, 5mm groove width, operates on 3.3-5V DC with 15mA current, and digital switching output. It can directly connect its DO output to a microcontroller port to detect speed or block detection. The DO output can also connect to relays, switches, buzzers. The module requires connection of VCC to 3.3-5V power, GND, DO output, and has an unused AO pin.

Uploaded by

Hassan Allawi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Feature:

Imported groove coupler sensor


A fixed bolt hole for easy installation
Used wide voltage LM393 comparator
Groove width of 5mm
Current: Around 15mA
Operating voltage DC 3.3V - 5V
Output signal: Digital switching outputs (0 and 1)
Dimensions: 3.2cm x 1.4cm

Specification:

DO output interface can be directly connected to a microcontroller IO port, if there is a block


detection sensor, such as the speed of the motor encoder can detect.
DO modules can be connected to the relay, limit switch, and other functions, it can also with
the active buzzer module, compose alarm.

Pin-out:

VCC Connect to the positive 3.3V - 5V power supply


GND Ground
DO TTL switch signal output
AO N/A

You might also like