Scribd
Upload
30 views

Model File Check List: (If No Workset Is Need For Submission)

This document is a checklist for submitting a Revit model file for the Punggol C6 & C7 project. It outlines 16 items to check in the model, including removing unnecessary files, views, and elements, purging the model, checking alignments and clearances, standardizing naming conventions, modeling elements correctly, and running interference checks between different systems. The submitter must check off each item once completed and obtain both a checker and approver's signature before submitting the file.

Uploaded by

WunNa
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
30 views

Model File Check List: (If No Workset Is Need For Submission)

This document is a checklist for submitting a Revit model file for the Punggol C6 & C7 project. It outlines 16 items to check in the model, including removing unnecessary files, views, and elements, purging the model, checking alignments and clearances, standardizing naming conventions, modeling elements correctly, and running interference checks between different systems. The submitter must check off each item once completed and obtain both a checker and approver's signature before submitting the file.

Uploaded by

WunNa
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Model file Check List

Name of Project : Punggol C6 & C7 File Submitted Date : 14/6/2017


Sub-Contractor Name : Khoon Native Revit
Service Name : Electrical dwf
Model File Name : KHOON ELECT- pdf

1 Open central file with Detached from Central and Audit selected . ( if No workset is need for submission)
2 Remove non transmittal linked-in file / remove unnecessary imported CAD file
3 Remove all non-required Views / Legends / Schedules / Sheets etc.
4 Remove unwanted Design Options
5 Purge model.
6 Correct Inserting Point ( Grid, Level ).
7 Check Ceiling Height or Head Room Clearance
8 All Riser are Inline/vertical elements are correct position as floor to floor alignment.
9 Graphic: Electrical system to be modelled in "Service Type" and filters with service type
10 Line Pattern - No Override.
11 Tagging size, Annotation and Leader are in to be standardize.
12 Family and View Name as agreed Naming System.
13 Elements/ Service are modelled as agreed method and correct colour code.
14 Service routine are parallel to building out line.
15 Use the TAB key to check the connectivity of your duct, pipe and electrical systems.
16 Interference Checks ( Clash Detection/Report)
Please run Interference check between such as Pipe Vs Pipe, Duct Vs Duct, Pipe Vs Duct and
Structural Column Vs Duct etc. List down all your checked categories in below table.
Categories Categories Result Zero
Clash
example : Duct example : Duct N.A
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

Checked by :__________________

Approved by : ________________

You might also like