Scribd
Upload
553 views1 page

MK5PFC-II Functional Block Diagram

This document provides a block diagram and description of the circuit operation for an MK5PFC-II Power Supply. The power supply takes in AC mains input which is then filtered and sent to a power factor correction converter. A primary housekeeping controller monitors the mains input and output feedback to control startup, shutdown, and output regulation. An isolated DC/DC converter provides multiple isolated and regulated DC outputs while monitoring output voltage, current, and faults. Safety isolation is provided between primary and secondary circuits.

Uploaded by

Elvis Linares
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
553 views1 page

MK5PFC-II Functional Block Diagram

This document provides a block diagram and description of the circuit operation for an MK5PFC-II Power Supply. The power supply takes in AC mains input which is then filtered and sent to a power factor correction converter. A primary housekeeping controller monitors the mains input and output feedback to control startup, shutdown, and output regulation. An isolated DC/DC converter provides multiple isolated and regulated DC outputs while monitoring output voltage, current, and faults. Safety isolation is provided between primary and secondary circuits.

Uploaded by

Elvis Linares
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

MK5PFC-II Power Supply Block Diagram

AC Input PFC Isolated DC


Mains Mains DC/DC Outputs
Input Filtering Conveter

AC Switched Primary Output


Mains Housekeeping Monitoring
Monitor Control Control and Control
Output

Low Isolation
Power AC
Signal

Description of circuit operation


1. AC Mains Input : AC supply source, nominally 110Vac to 240Vac.
2. Input Mains Filtering : Provides current inrush surge limiting at power up, EMI filtering
between the mains input supply and high frquency switching components inside the
converter and protection against mains supply overvoltage surges.
3. Switched Mains Control : Isolated control circuitry for switching mains supply on and off
to the AC monitor output.
4. AC Monitor Output : Electronically switched mains output supply.
5. Low Power AC Signal : Isolated input signal for controlling the AC monitor supply.
6. PFC : Power factor correction converter for achieving near unity power factor loading on
the mains supply input.
7. Primary Housekeeping Control : Monitors the mains input voltage and output feedback
signals to control startup, shutdown and output regulation of the main converters.
8. Isolated DC/DC Converter : DC to DC power conversion stage incorporating safety
isolation between the mains input and DC output supplies. Provides fault protected
multiple output rails for the main load and auxilliary loads.
9. Output Monitoring and Control : Monitors overvoltage, undervoltage, current limit and
output voltage regulation and feeds back the information to the primary control circuits for
the control of shutdown and voltage regulation.
10. Isolation : Provides for safety isolation of the feedback control signals between primary
and secondary circuits.
11. DC Outputs : Fully protected and regulated DC output supply for powering the load as
required.

You might also like