Scribd
Upload
294 views2 pages

Connect As Below:: Serial Suite: ECU Plug

The document provides instructions for connecting an ECU plug to a serial suite and putting the ECU into bootstrap mode. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground, and green wire to the 1 pin green K line on the ECU plug. It further instructs to connect two 680 ohm resistors as pictured to put the ECU into bootstrap mode, which then allows reading and writing of the ECU.

Uploaded by

Osmar Augusto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
294 views2 pages

Connect As Below:: Serial Suite: ECU Plug

The document provides instructions for connecting an ECU plug to a serial suite and putting the ECU into bootstrap mode. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground, and green wire to the 1 pin green K line on the ECU plug. It further instructs to connect two 680 ohm resistors as pictured to put the ECU into bootstrap mode, which then allows reading and writing of the ECU.

Uploaded by

Osmar Augusto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Connect as below:

Serial Suite: ECU Plug:

Red to 2 Pins Red (Power Supply +12 Volt)


Black to 1 Pins Black (Ground)
Green to 1 Pins Green (K Line)

Piasiniengineering [email protected] http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
Bootstraps Pin:

Connect the 2 resistor (680 Ohm) like in the picture, then ECU is in Bootstraps Mode,
Now you can read and write the ECU.

Piasiniengineering [email protected] http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like