BH1415F

Audio ICs

Wireless Audio Link IC

BH1415F

The BH1415F is a FM stereo transmitter IC that transmits simple configuration. The IC consists of a stereo modulator for
generating stereo composite signals and a FM transmitter for broadcasting a FM signal on the air. The stereo modulator
generates a composite signal which consists of the MAIN, SUB, and pilot signal from a 38kHz oscillator.
The FM transmitter radiates FM wave on the air by modulating the carrier signal with a composite signal.

!Applications
CD changer, Car TV, Car navigation, Wireless speakers, Personal computer (sound board), Game machine

!Features
1) It is possible to improve the timbre because it has the pre-emphasis circuit, limiter circuit, and the low-pass filter circuit.
2) Built-in pilot-tone system FM stereo modulator circuit.
3) The transmission frequency is stable because it has a PLL system FM transmitter circuit.
4) PLL data input (CE, CK, DA) by serial input.

!Absolute maximum ratings (Ta = 25C, In measurement circuit.)

Parameter Symbol Limits Unit Conditions
Supply voltage VCC +7.0 V Pin8,12
Data input voltage VIN-D 0.3 to VCC+0.3 V Pin15,16,17,18
Phase comparator output voltage VOUT-P 0.3 to VCC+0.3 V Pin7

Power dissipation Pd 450 mW
Storage temperature Tstg 55 to +125 C
Derating : 4.5mW/C for operation above Ta=25C.

!Recommended operating conditions (Ta = 25C)

Parameter Symbol Min. Typ. Max. Unit Conditions
Operating supply voltage VCC 4.0 6.0 V Pin8,12
Operating temperature Topr 40 +85 C
Audio input level VIN-A 10 dBV Pin1,22
Audio input frequency band fIN-A 20 15k Hz Pin1,22
Pre-emphasis time constant set up range t PRE 155 sec Pin2,21
Transmission frequency fTX 70 120 MHz Pin9,11
Control terminal "H" level input voltage VIH 0.8VCC VCC V Pin15,16,17,18
Control terminal "L" level input voltage VIL GND 0.2VCC V Pin15,16,17,18

1/3
 Audio ICs

!Block diagram

1
22
R-ch INPUT L-ch INPUT

2
21
PRE-EMPHASIS TIME CONSTANT PRE-EMPHASIS TIME CONSTANT

3
20
LPF TIME CONSTANT LPF TIME CONSTANT

Pre-emphasis
and Limiter

LPF
LPF

4
19

VCC
FILTER PILOT SIGNAL ADJUST

MPX

5
+
18
COMPOSITE SIGNAL OUTPUT AUDIO MUTING

MUTE

6
17

GND DATA

GND

7
16

PLL PHASE DETECTOR OUTPUT CLOCK

2
1

Phase
detector

8
Shift register
15

VCC
VCC CHIP ENABLE
1

1
50

19

9
14

RF OSCILLATOR X'tal OSCILLATOR

OSC
4
1
13

10
RF GND X'tal OSCILLATOR

RF GND
RF
Program counter
12

11
RF OUTPUT PLL VCC
PLL VCC

2/3
BH1415F
 BH1415F
Audio ICs

No. Control unit / Data Contents

(2) MULTIPLEXER It changes a stereo and monaural operation.

MONO Condition of the composite signal

MONO
0 Monaural operation L+R , Pilot OFF
s
1 Stereo operation L+R+(L-R),sinst+Psin 2 t

(2) PHASE DETECTOR It controls charge pump output by the phase comparator compulsorily.

PD0 PD1 Charge pump output

PD0, PD1
0 0 Usual operation

0 1 Compulsion by Low

1 0 Compulsion by High

1 1 High impedance

(3) TEST MODE It is data for the LSI test.

Always in T0 Input "1".

T0, T1
Always in T1 Input "0".

!External dimensions (Units : mm)

13.6 0.2

22 12
7.8 0.3

5.4 0.2

0.15 0.1

1 11
1.8 0.1

0.11

1.27 0.4 0.1 0.3Min.

0.15

SOP22

3/3
Appendix

Notes
No technical content pages of this document may be reproduced in any form or transmitted by any
means without prior permission of ROHM CO.,LTD.
The contents described herein are subject to change without notice. The specifications for the
product described in this document are for reference only. Upon actual use, therefore, please request
that specifications to be separately delivered.
Application circuit diagrams and circuit constants contained herein are shown as examples of standard
use and operation. Please pay careful attention to the peripheral conditions when designing circuits
and deciding upon circuit constants in the set.
Any data, including, but not limited to application circuit diagrams information, described herein
are intended only as illustrations of such devices and not as the specifications for such devices. ROHM
CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any
third party's intellectual property rights or other proprietary rights, and further, assumes no liability of
whatsoever nature in the event of any such infringement, or arising from or connected with or related
to the use of such devices.
Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or
otherwise dispose of the same, no express or implied right or license to practice or commercially
exploit any intellectual property rights or other proprietary rights owned or controlled by
ROHM CO., LTD. is granted to any such buyer.
Products listed in this document use silicon as a basic material.
Products listed in this document are no antiradiation design.

The products listed in this document are designed to be used with ordinary electronic equipment or devices
(such as audio visual equipment, office-automation equipment, communications devices, electrical
appliances and electronic toys).
Should you intend to use these products with equipment or devices which require an extremely high level of
reliability and the malfunction of with would directly endanger human life (such as medical instruments,
transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other
safety devices), please be sure to consult with our sales representative in advance.

About Export Control Order in Japan

Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control
Order in Japan.
In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause)
on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction.

Appendix1-Rev1.0