100% found this document useful (2 votes)
2K views3 pages

Motionless Electromagnetic Generator (MEG)

The document describes a motionless electromagnetic generator (MEG) that produces overunity power output. It uses an iron core with coils and capacitors to create resonance between the input and output coils. This directs power flow in a closed loop system and allows the MEG to generate 12V and up to 60W of power from a 9V battery impulse startup, demonstrating an overunity ratio. The MEG provides a source of low-to-medium power electricity without external motion.

Uploaded by

dundonalds
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
100% found this document useful (2 votes)
2K views3 pages

Motionless Electromagnetic Generator (MEG)

The document describes a motionless electromagnetic generator (MEG) that produces overunity power output. It uses an iron core with coils and capacitors to create resonance between the input and output coils. This directs power flow in a closed loop system and allows the MEG to generate 12V and up to 60W of power from a 9V battery impulse startup, demonstrating an overunity ratio. The MEG provides a source of low-to-medium power electricity without external motion.

Uploaded by

dundonalds
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Motionless electromagnetic generator (MEG)

As the fields are being added, the output power is higher than the input power. The system becomes
overunity. For long time, the system has been built only in this version. It was necessary to supply the
power into the input coil to get power from the output one. It was not possible to connect the coils
together because there is also a lot of reactive power consumed by the input coil, ruining the overunity
state. Also the output coil was not fully utilized due to its inductive nature. Finally, this problem was
solved by adding the resonance capacitors to both of the coils. Another problem appeared when
researchers were trying to connect the coils together to make an closed loop system - there was
nothing to determine the direction of the power circulation. There is no difference between the input
and output coil. This problem was solved by adding tho power silicon diodes between them. The
diodes effectively directing the power inside the overunity system.

My Motionless electromagnetic free energy generator is using three column magnetic core made of
iron sheet. Iron core has the advantage over the ferrite core in much higher permeability, so that the
magnetic losses are lower. My coils have 7 turns each. This system generates 12V and maximum
power was slightly over 60 Watts. I used neodymium magnet from and old hard drive. The diodes are
rated 3 Amps and 1000 Volts, but the voltage rating seems to be an overkill. The capacitors are 470
nanofarads, rated 250 Volts AC. The system is being started by connecting 9V battery to the input coil.
6 pcs of AA battery can also be used. It seems that the overunity ratio is more than 12/9 as 9V impulse
is enough to start the 12V system. It is also necessary to note that the output voltage is alternating
(AC).

The expected life of this free energy device is very long due to the motionless construction. It is a nice
free electricity source of low to medium power levels. The construction of generator of higher power
and higher voltage is also possible, but may be dangerous. The output frequency can also be unstable
and can differ from the mains one.
Motionless electromagnetic generator (MEG)

The Motionless electromagnetic generator (MEG) before startup and the MEG startup using a 9V
battery.

The Motionless electromagnetic generator of free energy in operation.


Motionless electromagnetic generator (MEG)

The Motionless electromagnetic generator working prototype held in hand (left photo). The generator
powering a 12V 60W light bulb (right photo).

You might also like