Scribd
Upload
26 views

Step 1: Firstly, Select The Material

The document outlines 14 steps to perform a structural analysis in a modeling program. It involves selecting materials, beam sections, components, nodes, constraints, loads, load steps, and results displays. The analysis is run and results are displayed as contours and changed to different result types.

Uploaded by

Sarah Harun
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
26 views

Step 1: Firstly, Select The Material

The document outlines 14 steps to perform a structural analysis in a modeling program. It involves selecting materials, beam sections, components, nodes, constraints, loads, load steps, and results displays. The analysis is run and results are displayed as contours and changed to different result types.

Uploaded by

Sarah Harun
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

Step 1: Firstly, select the material

Step 2: Select the beam section and then insert the radius=220 mm
Step 3: Then, select the beam section

Step 4: Select the component


Step 5: Select the nodes

Step 6: Select the load collector and type SPC


Step 7: Select the node A to make line

Step 8: Select the constrain


Step 9: Then, select the load collector and type force.

Step 10: Then make the force at the beam


Step 11: Select the second force

Step 12: Select the load steps


Step 13: Then save as and select optic struct and the result will display. So, the
result display is Analysis completed.

Step 14: Select the contour and then select apply. Then the result will display.
Step 15: Then changed the result type and select apply.

You might also like