Dcom Question
Dcom Question
{
x ( t )= A 0<t T
0 t> T
xi. Draw the waveform Binary ASK and FSK.
xii. Write the probability of error comparison of ASK, FSK and PSK.
2. i. Drive the expression for Signal to noise ratio (S/N) db in PCM system. .. 3x2
ii. The information in an analog waveform with peak to peak to value is 10 volt and frequency
3KHz. If the sampling frequency is 60% higher than the natural sampling frequency of analog
signal, when it passes through the 4-bit PCM. Then calculate
a) Number of quantization level.
b) Step size
c) Bandwidth
d) S/N in db
iii. Explain the Matched filter. Drive the expression for probability of error in the matched filter.
iv. Explain the Non- Uniform Quantization method for waveform coding with example.
OR
i. Explain the modulation and demodulation of delta modulator using block diagram.
f Am
ii. A sine wave of frequency m and amplitude is applied to delta modulator having
step size . Show that the overload distortion will occur if
Am>
2 f mT s
iii. Compute the matched filter output response over (0, T) to the pulse waveform
{
t
x ( t )= e 0 t T
0 otherwise
iv. Draw the HDB3 and B8ZS line coding for 10000110000000011.
ii. Draw the constellation diagram of the binary ASK, FSK and PSK. Find signaling distance.
iv. A binary ASK system for equally probable messages having peak amplitude is 0.2 volt
uses 2 sec bits and channel has N 0 1015 W /H z . Determine the probability of error.
OR
receiver receives the waveforms s1(t)=Acos t and s2(t)= --Acos t . The received signals
are coherently detected using a matched filter. If A=10mv and single sided noise power spectral
N0
density is =10 -11W/Hz. Assume that the signal power and energy per bit are normalized.