Scribd
Upload
34 views

Arduino Soil Moisture Sensor Schematic

This document describes an Arduino soil moisture sensor project that uses two wires placed in soil as a variable resistor. The resistance changes with soil moisture and is measured in a voltage divider configuration by the Arduino. When the soil reaches a certain moisture level, a LED will light up to signal the plant needs water. The code samples show how to read the analog voltage from the sensor and turn on the LED when the moisture level exceeds a threshold.

Uploaded by

Bhartendu Sharma
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
34 views

Arduino Soil Moisture Sensor Schematic

This document describes an Arduino soil moisture sensor project that uses two wires placed in soil as a variable resistor. The resistance changes with soil moisture and is measured in a voltage divider configuration by the Arduino. When the soil reaches a certain moisture level, a LED will light up to signal the plant needs water. The code samples show how to read the analog voltage from the sensor and turn on the LED when the moisture level exceeds a threshold.

Uploaded by

Bhartendu Sharma
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

This is a simple arduino project for a soil moisture sensor that will light up a LED at a certain

moisture level. It uses Arduino Duemilanove microcontroller board. Two wires placed in the soil
pot form a variable resistor, whose resistance varies depending on soil moisture. This variable
resistor is connected in a voltage divider configuration, and Arduino collects a voltage
proportional to resistance between the 2 wires.

Insert the 2 probes (wires, pcb) in the dry soil and measure the resistance value and then pour
water and measure it again.
Use a mid value for the resistor (eg: 50k for 100k in dry soil and 10k in wet).
Related Products: Sensors | Specialized Sensor
The other method to find the resistors value is to try different values or use a potentiometer.
Insert the probes into the soil that has the desired moisture when to light up the LED and signal
that the plant needs water.
Adjust the potentiometer and see the point at which it starts to light. Measure the potentiomenter
current value and replace it with a fixed resistor.

Arduino soil moisture sensor schematic


Project source code
const int VAL_PROBE = 0; // Analog pin 0
const int MOISTURE_LEVEL = 250; // the value after the LED goes ON

void setup() {
Serial.begin(9600);
}

void LedState(int state) {


digitalWrite(13, state);
}

void loop() {
int moisture = analogRead(VAL_PROBE);
Serial.println(moisture);

if(moisture > MOISTURE_LEVEL) {


LedState(HIGH);
} else {
LedState(LOW);
}
delay(100);
}

You might also like