Scribd
Upload
2K views1 page

Involute Spline Strength Calculations

This document provides information about involute spline shafts and bushings, including their features, design concepts, and points to observe during use. It discusses the surface strength formula for splines and the factors that determine the allowable transmission force and torque. It also notes that spline shafts and bushings are heat-treated for abrasion resistance and lubrication is important when there is sliding movement between parts.

Uploaded by

Rjgandhi65
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Involute Spline Strength Calculations

This document provides information about involute spline shafts and bushings, including their features, design concepts, and points to observe during use. It discusses the surface strength formula for splines and the factors that determine the allowable transmission force and torque. It also notes that spline shafts and bushings are heat-treated for abrasion resistance and lubrication is important when there is sliding movement between parts.

Uploaded by

Rjgandhi65
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SVSVI

Involute Spline Shafts & Bushings


Gears
Spur
Helical
Gears
Internal
Gears
Racks

Features

Characteristics of Gear Couplings The surface strength of Spline


CP Racks
& Pinions

The design concept of the spline surface strength is the same as


SV and SVI series are made according to the automotive involute that of a key. Here is the formula for the allowable transmission
force (N) of spline.
spline standard, JIS D 2001: 1959 (FLAT ROOT SIDE FIT, Backlash
0.06 to 0.15)
F zhwl
Involute spline shafts and bushings are thermal refined to have
Gears
Miter

good abrasion-resistance.
And the formula of allowable torque T (Nm) of spline with re-
Spline bushings may be made in CAC (bronze) type material as a
spect to the surface strength.
special custom order item.

T Fdw
Gears
Bevel

Points to observe during use 2000

In designing a spline shafts, besides considering the surface strength,


Be sure not to bend shafts or break teeth when perform- we should take into account the torsional and bending stresses of the
ing secondary operations on SV Involute Spline shafts. spline.
Screw
Gears

When using SVI Spline Bushings with sliding movement,


Here
lubrication is necessary on the sliding surface. To prevent
Contact ratio of surface 0.75 (assumed)
scuffing, it is recommended to apply lubricating grease. z Number of teeth number of teeth (z) of spline from the table
Products Gearboxes Gear Pair

If used in applications where oil contamination is not de- hwContact depth of tooth 1.485
Worm

sirable, solid lubrication is recommended. l Contact length of spline Total length (A) of involute spline bushing
Allowable surface stress of spline 19.61MPa (2kgf/mm2) (assumed)
dwContact diameter (mm) Tip diameter of spline shaft D - hw
Other Bevel

422

You might also like