Chhotu Ram Rural Institute Of Technology (A) impact ionisation

(B) strong electric field across the junction

Branch- Electrical Engineering (C) emission of electrons
(D) rise in temperature
M.M.45 7. Dynamic plate resistance of pentode is of the order of
Time 30 Minutes (A) 1 K (B) 10 K
(C) 100 K (D) 1M
1. The unit of magnetic flux is
(a) Henry 8. Reciprocal of reluctance is
(b) Weber (a) reluctivity
(c) Ampereturn/weber (b) permeance
(d) Ampere/metre (c) permeability
(d) susceptibility
2. A resistor with colour bands Red, Violet, Green and Black will 9. The varactor diode is usually
have a value
(A) 27 K 10% K (B) 2.7 M 20% K (A) Forward biased (B) reverse biased
(C) 270 K 5% K (D) 2.7 K 2% K (C) Unbiased (D) holes and electronics
10. The diode in which impurities are heavily doped is
3. An air gap is usually inserted in magnetic circuits to
(a) Increase m.m.f. (A) Varactor diode (B) PIN diode
(b) Increase the flux (C) Tunnel diode (D) Zener diode
(c) Prevent saturation
(d) None of the above 11. The unit of reluctance is
(a) metre/henry
4. A material for good magnetic memory should have (b) henry/metre
(a) low hysteresis loss (c) henry
(b) high permeability (d) 1/henry
(c) low retentivity
(d) high retentivity 12. Laminated cores, in electrical machines, are used to reduce
(a) copper loss
5. Two resistances R1 and R2 give combined resistance of 4.5 ohms (b) eddy current loss
when in series and 1 ohm when in parallel. The resistances are (c) hysteresis loss
(a) 3 ohms and 6 ohms (b) 3 ohms and 9 ohms (d) all of the above
(c) 1.5 ohms and 3 ohms (d) 1.5 ohms and 0.5 ohm
13. An Op-amp as a voltage follower has a voltage gain of
6. Avalanche breakdown results basically due to (A) Infinity (B) Zero
(C) Unity (D) less than unity
19. For open control system which of the following statements is
14.Which of the following circuit element stores energy in the incorrect ?
electromagnetic field ? (a) Less expensive
(a) Inductance (b) Recalibration is not required for maintaining the required quality
(b) Condenser of the output
(c) Variable resistor (c) Construction is simple and maintenance easy
(d) Resistance (d) Errors are caused by disturbances

15. An intrinsic semiconductor at the absolute zero temperature 20. A control system in which the control action is somehow
(A) behaves like a metallic conductor dependent on the output is known as
(B) behaves like an insulator
(C) has a large number of holes (a) Closed loop system
(D) has a large number of electrons (b) Semiclosed loop system
(c) Open system
16. Which of the following diodes is operated in reverse bias mode ? (d) None of the above
(A) P-N junction (B) Zener
(C) Tunnel (D) Schottky 21. The main function of a fuse is to
(a) protect the line
17.The direction of induced e.m.f. can be found by (b) open the circuit
(a) Laplace's law (c) protect the appliance
(b) Lenz's law (d) prevent excessive currents
(c) Fleming's right hand rule (e) none of the above
(d) Kirchhoff s voltage law
22. On which of the following routine tests are conducted ?
(a) Oil circuit breakers
18. In an open loop control system (b) Air blast circuit breakers
(a) Output is independent of control input (c) Minimum oil circuit breakers
(b) Output is dependent on control input (d) All of the above
(c) Only system parameters have effect on the control output
(d) None of the above 23. SF6 gas
(a) is yellow in colour
(b) is lighter than air
(c) is nontoxic
(d) has pungent small
(e) none of the above
 (d) none of the above
24. In closed loop control system, with positive value of feedback 30. To reduce short circuit fault currents are used.
gain the overall gain of the system will (a) reactors
(a) decrease (b) resistors
(b) increase (c) capacitors
(c) be unaffected (d) none of the above
(d) any of the above
31. . Bus coupler is very essential in arrangement
(a) single bus
(b) double bus, double breaker
25. Which of the following is an open loop control system ? (c) main and transfer bus
(a) Field controlled D.C. motor (d) all of the above
(b) Ward leonard control
(c) Metadyne 32. What is the power factor?
(d) Stroboscope a. ratio of true power to apparent power
b. peak power times .707
26. Air blast circuit breaker is used for c. sin of the phase difference between E and I
(a) over currents d. cos of the phase angle between true power and apparent power
(b) short duty
(c) intermittant duty 33. The Superposition theorem is essentially based on the concept
(d) repeated duty of
(A) duality. (B) linearity. (C) reciprocity. (D) non-linearity.
27. Ohms law is not applicable to
(a) dc circuits (b) high currents
(c) small resistors (d) semi-conductors 34 Cells are connected in parallel in order to
(A) increase the voltage available. (B) reduce cost of wiring.
28. H.R.C. fuses provide best protection against (C) increase the current available. (D) reduce the time required to
(a) overload fully charge them after use.
(b) reverse current
(c) open-circuits
(d) short-circuits 35 The power factor of a purely resistive circuit is
(A) zero. (B) unity. (C) lagging. (D) leading.
29. Resistance grounding is used for voltage between
(a) 33kVto66kV 36 The combined resistance of two equal resistors connected in
(b) HkVto33kV parallel is equal to
(c) 3.3kVand ll kV
(A) One half the resistance of one resistor. (B) Twice the resistance (a) lap winding
of one resistor. (b) wave moving
(C) Four times the resistance of one resistor. (D) One fourth the (c) duplex winding
resistance of one resistor. (d) any of the above

37 Thevenins equivalent circuit consists of _________. 43. A good control system has all the following features except
(A) Series combination of RTh, ETh and RL. (a) good stability
(B) (B) Series combination of RTh, ETh. (b) slow response
(C) Parallel combination of RTh, ETh. (c) good accuracy
(D) Parallel combination of RTh, ETh and RL. (d) sufficient power handling capacity

38. The frequency of DC supply is__________. 44. A car is running at a constant speed of 50 km/h, which of the
(A) Zero. (B) 16 Hz. (C) 50 Hz. (D) 100 Hz. following is the feedback element for the driver ?

39.When a low resistance is connected in parallel with a high (a) Clutch

resistance, the combined resistance is (b) Eyes
(A) Always more than the high resistance. (c) Needle of the speedometer
(B) Always less than the low resistance. (d) Steering wheel
(C) Always between the high resistance & low resistance. (e) None of the above
(D) Either lower or higher than low resistance depending on the
value of high resistance. 45. A network that does not have either voltage or current sources is
called
40. In open loop system (A) Active network. (B) Passive network. (C) Resistive network.
(a) the control action depends on the size of the system (D) Dummy network.
(b) the control action depends on system variables
(c) the control action depends on the input signal
(d) the control action is independent of the output

41. has tendency to oscillate.

(a) Open loop system
(b) Closed loop system
(c) Both (a) and (b)
(d) Neither (a) nor (b)

42. A D.C. welding generator has

 20 A
21 D
22 D
23 C
Answer sheet 24 A
25 A
26 D
1 B 27 D
2 B 28 D
3 C 29 C
4 D 30 A
5 C 31 C
6 A 32 A
7 D 33 B
8 B 34 C
9 B 35 B
10 C 36 A
11 D 37 B
12 B 38 A
13 C 39 B
14 A 40 D
15 B 41 B
16 B 42 A
17 B 43 B
18 A 44 C
19 B 45 B