Assignment 2 Compare Travelling Wave and Standing Wave Antennas

ASSIGNMENT 2
Compare Travelling wave and Standing wave antennas
TRAVELLING WAVE ANTENNAS

A mechanical wave is a disturbance that is created by a vibrating object and subsequently
travels through a medium from one location to another, transporting energy as it moves.
The mechanism by which a mechanical wave propagates itself through a medium
involves particle interaction; one particle applies a push or pull on its adjacent neighbor,
causing a displacement of that neighbor from the equilibrium or rest position. As a wave
is observed traveling through a medium, a crest is seen moving along from particle to
particle. This crest is followed by a trough that is in turn followed by the next crest. In
fact, one would observe a distinct wave pattern (in the form of a sine wave) traveling
through the medium. This sine wave pattern continues to move in uninterrupted fashion
until it encounters another wave along the medium or until it encounters a boundary with
another medium. This type of wave pattern that is seen traveling through a medium is
sometimes referred to as a traveling wave.
Traveling waves are observed when a wave is not confined to a

given space along the medium. The most commonly observed
traveling wave is an ocean wave. If a wave is introduced into an
elastic cord with its ends held 3 meters apart, it becomes confined in
a small region. Such a wave has only 3 meters along which to travel.
The wave will quickly reach the end of the cord, reflect and travel back in the opposite
direction. Any reflected portion of the wave will then interfere with the portion of the
wave incident towards the fixed end. This interference produces a new shape in the
medium that seldom resembles the shape of a sine wave. Subsequently, a traveling wave
(a repeating pattern that is observed to move through a medium in uninterrupted fashion)
is not observed in the cord. Indeed there are traveling waves in the cord; it is just that
they are not easily detectable because of their interference with each other. In such
instances, rather than observing the pure shape of a sine wave pattern, a rather irregular
and non-repeating pattern is produced in the cord that tends to change appearance over
time. This irregular looking shape is the result of the interference of an incident sine wave
pattern with a reflected sine wave pattern in a rather non-sequenced and untimely manner.
Both the incident and reflected wave patterns continue their motion through the medium,
meeting up with one another at different locations in different ways. For example, the
middle of the cord might experience a crest meeting a half crest; then moments later, a
crest meeting a quarter trough; then moments later, a three-quarters crest meeting a one-
fifth trough, etc. This interference leads to a very irregular and non-repeating motion of
the medium. The appearance of an actual wave pattern is difficult to detect amidst the
irregular motions of the individual particles.
STANDING WAVE ANTENNAS
It is however possible to have a wave confined to a given space in a medium and still
produce a regular wave pattern that is readily discernible amidst the motion of the
medium. For instance, if an elastic rope is held end-to-end and vibrated at just the right
frequency, a wave pattern would be produced that assumes the shape of a sine wave and
is seen to change over time. The wave pattern is only produced when one end of the rope
is vibrated at just the right frequency. When the proper frequency is used, the interference
of the incident wave and the reflected wave occur in such a manner that there are specific
points along the medium that appear to be standing still. Because the observed wave
pattern is characterized by points that appear to be standing still, the pattern is often
called a standing wave pattern. There are other points along the medium whose
displacement changes over time, but in a regular manner. These points vibrate back and
forth from a positive displacement to a negative displacement; the vibrations occur at
regular time intervals such that the motion of the medium is regular and repeating. A
pattern is readily observable.
The diagram at the right depicts a standing wave pattern in a medium. A snapshot of the
medium over time is depicted using various colors. Note that point A on the medium
moves from a maximum positive to a maximum negative displacement over time. The
diagram only shows one-half cycle of the motion of the standing wave pattern. The
motion would continue and persist, with point A returning to the same maximum positive
displacement and then continuing its back-and-forth vibration between the up to the down
position. Note that point B on the medium is a point that never moves. Point B is a point
of no displacement. Such points are known as nodes and will be discussed in more detail
later in this lesson. The standing wave pattern that is shown at the right is just one of
many different patterns that could be produced within the rope. Other patterns will be
discussed later in the lesson.
Compare between resonant antennas and non

resonant antennas
RESONANT ANTENNAS
The majority of antenna designs are based on the resonance principle. This relies on the
behaviour of moving electrons, which reflect off surfaces where the dielectric constant
changes, in a fashion similar to the way light reflects when optical properties change. In
these designs, the reflective surface is created by the end of a conductor, normally a thin
metal wire or rod, which in the simplest case has a feed point at one end where it is
connected to a transmission line. The conductor, or element, is aligned with the electrical
field of the desired signal, normally meaning it is perpendicular to the line from the
antenna to the source (or receiver in the case of a broadcast antenna). [15]
The radio signal's electrical component induces a voltage in the conductor. This causes an
electrical current to begin flowing in the direction of the signal's instantaneous field.
When the resulting current reaches the end of the conductor, it reflects, which is
equivalent to a 180 degree change in phase. If the conductor is 14 of a wavelength long,
current from the feed point will undergo 90 degree phase change by the time it reaches
the end of the conductor, reflect through 180 degrees, and then another 90 degrees as it
travels back. That means it has undergone a total 360 degree phase change, returning it to
the original signal. The current in the element thus adds to the current being created from
the source at that instant. This process creates a standing wave in the conductor, with the
maximum current at the feed.
NON RESONANT ANTENNAS
A long-wire or traveling-wave antenna which does not have natural frequencies of

oscillation, and responds equally well to radiation over a broad range of frequencies.
Nonresonant antennas have wider bandwidth over resonant antenna but have less
sensivity than resonant antenna Secondary effects can be cross channel interference and
intermodulation distortion in following circuits.So for example, say there is a local high
power transmitter and you want to look at a small signal at a different frequency. Any RF
pre-amplifier has to handle the high power signal as well as presenting a low noise figure
at the wanted signal frequency. Any non-linearity in the pre-amp will cause interference
by mixing with other unwanted signals and many could be reflected back into the wanted
signal band. Only front end filtering (or a resonant aerial) will prevent this. (post amp
filtering cannot remove in-band signals) This is why often front end RF amps have to be
designed as power amps. They have to handle the highest power signal whether the
wanted one or (usually) not.

Assignment 2 Compare Travelling Wave and Standing Wave Antennas

Uploaded by

Copyright:

Available Formats

Assignment 2 Compare Travelling Wave and Standing Wave Antennas

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Assignment 2 Compare Travelling Wave and Standing Wave Antennas

Uploaded by

Copyright:

Available Formats

ASSIGNMENT 2

Compare Travelling wave and Standing wave antennas

TRAVELLING WAVE ANTENNAS

Traveling waves are observed when a wave is not confined to a

STANDING WAVE ANTENNAS

Compare between resonant antennas and non

NON RESONANT ANTENNAS

A long-wire or traveling-wave antenna which does not have natural frequencies of

You might also like