8809872588830

MATERIAL SAFETY DATA SHEET
SECTION 1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER

Product name: Loctite 542
Product-Code: 267431
Intended use: Anaerobic
Supplier:
HENKEL AUSTRALIA PTY. LIMITED
ADHESIVE TECHNOLOGIES
135-141 Canterbury Road
3137 Kilsyth, Victoria
Australia
Phone: +61 (3) 9724 6444
Emergency information: 24 HOUR EMERGENCY CONTACT NUMBER: 1800 032 379
SECTION 2. HAZARDS IDENTIFICATION

STATEMENT OF HAZARDOUS NATURE:
Hazardous according to the criteria of ASCC.
Classification of material Xn - Harmful
Risk phrases:
R20 Harmful by inhalation.
R36/37 Irritating to eyes and respiratory system.
R52/53 Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Safety phrases:
S23 Do not breathe vapour.
S25 Avoid contact with eyes.
S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
S51 Use only in well-ventilated areas.
S61 Avoid release to the environment. Refer to special instructions/Safety data sheets.
Dangerous Goods information:

Not classified as Dangerous Goods according to the criteria of the Australian Code for the Transport of Dangerous Goods by
Road and Rail (ADG Code).
Signal word:
None
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Identity of ingredients:
Chemical ingredients CAS-No. Proportion

Cumene hydroperoxide 80-15-9 1- 3 %
non hazardous ingredients~ > 60 %
Revision: 16.11.2010
Page 1 of 5 Loctite 542
SECTION 4. FIRST AID MEASURES

Ingestion: Rinse out mouth, drink 1-2 glasses of water, do not induce vomiting.
Seek medical advice.
Skin: Rinse with running water and soap.

Seek medical advice.
Eyes: Rinse immediately with plenty of running water (for 10 minutes). Seek medical attention if
necessary.
Inhalation: If mist or vapor of this product is inhaled, remove person immediately to fresh air. Seek
medical attention if symptoms develop or persist.
First Aid facilities: Eye wash and safety shower
SECTION 5. FIRE FIGHTING MEASURES

Suitable extinguishing media: Carbon dioxide, foam, powder
Improper extinguishing agent: None known
Decomposition products in case of Oxides of carbon, oxides of nitrogen, irritating organic vapors.
fire:
Particular danger in case of fire: None
Special protective equipment for Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.
fire-fighters:
SECTION 6. ACCIDENTAL RELEASE MEASURES

Personal precautions and Avoid skin and eye contact.
emergency procedures:
Ensure adequate ventilation.
See advice in chapter 8
Environmental precautions: Do not let product enter drains.
Clean-up methods: For small spills wipe up with paper towel and place in container for disposal.
For large spills absorb onto inert absorbent material and place in sealed container for
disposal.
Dispose of contaminated material as waste according to Chapter 13.
SECTION 7. HANDLING AND STORAGE

Precautions for safe handling: Use only in well-ventilated areas.
Prolonged or repeated skin contact should be avoided to minimise any risk of sensitisation.
Conditions for safe storage: Store in original containers at 8-21C (46.4-69.8F) and do not return residual materials to
containers as contamination may reduce the shelf life of the bulk product.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
National exposure standards:
contains no components
Engineering controls: Ensure good ventilation/suction at the workplace.
Eye protection: Wear protective glasses.
Skin protection: Wear suitable protective clothing.

The use of chemical resistant gloves such as Nitrile are recommended.
Please note that in practice the working life of chemical resistant gloves may be
considerably reduced as a result of many influencing factors (e.g. temperature). Suitable
risk assessment should be carried out by the end user. If signs of wear and tear are noticed
then the gloves should be replaced.
Respiratory protection: If inhalation risk exists, wear a respirator or air supplied mask complying with the
requirements of AS/NZS 1715 and AS/NZS 1716.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Appearance: brown
liquid
Odor: characteristic
Specific gravity: 1.08
pH: 3-6
Flash point: > 100 C (> 212 F)

Vapor pressure: 0.1 mm hg
Density: 1.08 g/cm3
Solubility: Solvent: Water, Not miscible
SECTION 10. STABILITY AND REACTIVITY
Stability: Stable under recommended storage conditions.
Conditions to avoid: Stable
Incompatible materials: Reaction with strong acids.

Reacts with strong oxidants.
Hazardous decomposition Irritating organic vapours.

products:
Oxides of carbon.
Sulphur oxides
nitrogen oxides
Hazardous polymerization: Will not occur
SECTION 11. TOXICOLOGICAL INFORMATION
HEALTH EFFECTS:
Ingestion: May cause gastrointestinal disturbances such as nausea, vomiting, abdominal pain, and
diarrhea.
Skin: Irritating to skin.
Eyes: Irritating to eyes. Causes excessive tearing. Eyelids may bond.
Inhalation: Harmful by inhalation.
Chronic effects: Repeated excessive dermal esposure may cause marked skin irritation and may increase
the possibility of allergic reactions.
Toxicity data:
Acute oral toxicity: Cumene hydroperoxide LD L0 (Mouse) = 5,000 mg/kg
80-15-9
SECTION 12. ECOLOGICAL INFORMATION

General ecological information: Do not empty into drains / surface water / ground water.
Harmful to aquatic organisms.
May cause long-term adverse effects in the aquatic environment.
SECTION 13. DISPOSAL CONSIDERATIONS

Waste disposal of product: Dispose of in accordance with local and national regulations.
Contribution of this product to waste is very insignificant in comparison to article in which
it is used
Disposal for uncleaned package: After use, tubes, cartons and bottles containing residual product should be disposed of as
chemically contaminated waste in an authorised legal land fill site or incinerated.
Disposal must be made according to official regulations.
SECTION 14. TRANSPORT INFORMATION

Road and Rail Transport:
Dangerous Goods information: Not classified as Dangerous Goods according to the criteria of the
Australian Code for the Transport of Dangerous Goods by Road and
Rail (ADG Code).
General information:
Not hazardous according to RID, ADR, ADNR, IMDG, IATA-DGR.
SECTION 15. REGULATORY INFORMATION
SUSDP Poisons Schedule: None
AICS: All components are listed or are exempt from listing on the Australian Inventory of
Chemical Substances (AICS).
SECTION 16. OTHER INFORMATION

Abbreviations/acronyms: ADGC - Australian Dangerous Goods Code
ASCC - Australian Safety and Compensation Council
SUSDP - Standard for the Uniform Scheduling of Drugs and Poisons
Date of previous issue: 01.12.2005
Disclaimer:
The percentage weight (% w/w) of ingredients is not to be taken as a specification
guaranteed by Henkel Australia Pty. Limited, but only as an approximate guide to the
content of hazardous ingredients in the material. The information contained herein does
not constitute a guarantee by Henkel Australia Pty. Limited concerning the properties of
the material. The information contained in this Material Safety Data Sheet is offered in
good faith and has been developed from what is believed to be accurate and reliable
sources. The information is offered without warranty, representation, inducement or
licence and Henkel Australia Pty. Limited assumes no legal responsibility for reliance
upon same. Henkel Australia Pty. Limited disclaims any liability for loss, injury or
damage incurred in connection with the use of the material or its associated Material
Safety Data Sheet. This information is not to be construed as a representation that the
material is suitable for any particular purpose or use except those conditions and
warranties implied by either Commonwealth or State statutes. Customers are encouraged
to make their own enquiries as to the material's characteristics and, where appropriate, to
conduct their own tests in the specific context of the material's intended use.

8809872588830

Uploaded by

Copyright:

Available Formats

8809872588830

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

8809872588830

Uploaded by

Copyright:

Available Formats

MATERIAL SAFETY DATA SHEET

SECTION 1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER

Intended use: Anaerobic

Phone: +61 (3) 9724 6444

Emergency information: 24 HOUR EMERGENCY CONTACT NUMBER: 1800 032 379

SECTION 2. HAZARDS IDENTIFICATION

Classification of material Xn - Harmful

Dangerous Goods information:

SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Chemical ingredients CAS-No. Proportion

SECTION 4. FIRST AID MEASURES

Skin: Rinse with running water and soap.

First Aid facilities: Eye wash and safety shower

SECTION 5. FIRE FIGHTING MEASURES

Improper extinguishing agent: None known

Particular danger in case of fire: None

SECTION 6. ACCIDENTAL RELEASE MEASURES

Environmental precautions: Do not let product enter drains.

SECTION 7. HANDLING AND STORAGE

SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION

National exposure standards:

Engineering controls: Ensure good ventilation/suction at the workplace.

Eye protection: Wear protective glasses.

Skin protection: Wear suitable protective clothing.

SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Flash point: > 100 C (> 212 F)

SECTION 10. STABILITY AND REACTIVITY

Stability: Stable under recommended storage conditions.

Conditions to avoid: Stable

Incompatible materials: Reaction with strong acids.

Hazardous decomposition Irritating organic vapours.

Hazardous polymerization: Will not occur

SECTION 11. TOXICOLOGICAL INFORMATION

Skin: Irritating to skin.

Eyes: Irritating to eyes. Causes excessive tearing. Eyelids may bond.

Inhalation: Harmful by inhalation.

SECTION 12. ECOLOGICAL INFORMATION

SECTION 13. DISPOSAL CONSIDERATIONS

SECTION 14. TRANSPORT INFORMATION

SECTION 15. REGULATORY INFORMATION

SUSDP Poisons Schedule: None

SECTION 16. OTHER INFORMATION

Date of previous issue: 01.12.2005

You might also like