Scribd
Upload
33 views1 page

Ee212 Homework

This document contains instructions for an electronics homework assignment. Students are asked to: 1) Simulate a MOSFET circuit and perform transient analysis to determine the voltage gain for different amplitudes of input voltage and comment on their observations. 2) Repeat the transient analysis for different values of transconductance coefficient and comment on the effect on output voltage and voltage gain. 3) Perform transient analysis while sweeping the load resistance value and comment on the effect on output voltage. 4) Repeat the transient analysis for a specific drain resistance and comment on the output voltage.

Uploaded by

AliBaranIşık
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views1 page

Ee212 Homework

This document contains instructions for an electronics homework assignment. Students are asked to: 1) Simulate a MOSFET circuit and perform transient analysis to determine the voltage gain for different amplitudes of input voltage and comment on their observations. 2) Repeat the transient analysis for different values of transconductance coefficient and comment on the effect on output voltage and voltage gain. 3) Perform transient analysis while sweeping the load resistance value and comment on the effect on output voltage. 4) Repeat the transient analysis for a specific drain resistance and comment on the output voltage.

Uploaded by

AliBaranIşık
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EE 212

Spring 2015-2016
HOMEWORK
ALL SECTIONS
Assigned May 26, 2016

Due: June 3, 2016

To be Collected Before the Final Examination Starts


Late submissions will not be accepted.

Construct the following circuit on a circuit simulator software. The MOSFET is n-channel
enhancement mode type.

i) Edit the default MOSFET model to change the threshold voltage to 1 V and the
transconductance coefficient to 6 mA/V2. Perform transient analysis for 1 msec and
observe the input&output voltages. Get a print out. What is the AC voltage gain of the
circuit? Explain how you selected the frequency and amplitude of Vin. Find the limit
for the amplitude of Vin for linear amplification (Hint: observe the changes in output
waveform for different amplitudes of Vin)

ii) Now you will see how the output voltage (and the voltage gain of the amplifier) is
affected when the transconductance coefficient is changed. Have the software perform
transient analysis for transconductance coefficients of 3, 6 and 10 mA/V2. Observe the
output voltages for different transconductance coefficients. Get a print out and
comment on what you have observed in this part.

iii) Have the software perform transient analysis for load resistances (RL) of 5K, 25K
and 50 K (transconductance coefficient=6 mA/V2) by sweeping the value of RL.
Observe the output voltages for three different load resistances (RL). Get a print out
and comment on what you have observed in this part.

iv) Have the software perform transient analysis for drain resistance (RD) of 50 K
(transconductance coefficient=6 mA/V2). Observe the output voltage. Get a print out
and comment on what you have observed in this part.

You might also like