Scribd
Upload
650 views3 pages

Workshop Lab Report - Job 5

This document provides instructions for making a two-step fitting with a 30mm x 30mm square hole cut out from the center of an iron metal sheet. The procedure involves filing, marking, cutting, drilling, and smoothing the sheet according to the provided drawing using hacksaw, file, hammer, chisel, and drilling machine. Safety precautions include maintaining a safe distance from tools, keeping a clear work area, and wearing protective equipment.

Uploaded by

Shehryar Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
650 views3 pages

Workshop Lab Report - Job 5

This document provides instructions for making a two-step fitting with a 30mm x 30mm square hole cut out from the center of an iron metal sheet. The procedure involves filing, marking, cutting, drilling, and smoothing the sheet according to the provided drawing using hacksaw, file, hammer, chisel, and drilling machine. Safety precautions include maintaining a safe distance from tools, keeping a clear work area, and wearing protective equipment.

Uploaded by

Shehryar Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

JOB # 05

OBJECT: To make a two-step fitting with a 30mm x 30mm


square hole cutout from the center.

DRAWING:

TOOLS: Hacksaw, Smooth File, Hammer, Chisel, Drilling


Machine

MATERIALS: Iron Metal Sheet

PROCEDURE:
1. File the sides of the metal sheet using smooth file.

2. Mark 90 mm, 90 mm length and width on the sheet


respectively.

3. Cut the marked metal sheet using a hacksaw.

4. Now mark other dimensions on the metal sheet according to


the drawing.

5. Cut the metal according to the marked dimensions using a


hacksaw and smoothen the cut surfaces using a smooth file.

6. Now mark the central square on the metal sheet and drill some
holes inside the marked square using a drilling machine.

7. Remove this piece from the metal sheet with the help of a
chisel and hammer.

8. File the inner surfaces of the square hole.

SAFETY PRECAUTIONS:
1. Dont get too close to the tools while working.

2. Stand in a suitable position.

3. Dont place the tools at the edge of the working table.

4. After job completion clear the working table.

5. Wear goggles, gloves and overhaul while working with


instruments.

You might also like