016-0171-084F - AccuBoom - Case IH SPX 3320-3330-4420 Sprayer and 20 Series FLX Liquid Bed - Installation Manual

Case IH SPX 3320/3330/4420
Sprayer and 20 Series FLX (Liquid

Bed) AccuBoom
Installation Manual
P/N 016-0171-084 Rev C 12/15
Copyright 2009, 2015

Disclaimer
While every effort has been made to ensure the accuracy of this document,
Raven Industries assumes no responsibility for omissions and errors. Nor is any
liability assumed for damages resulting from the use of information contained
herein.
Raven Industries shall not be held responsible or liable for the effects of
atmospheric conditions and sunspot activity on the performance of our products.
Raven Industries cannot guarantee the accuracy, integrity, continuity, or

availability of the GPS signal from the U.S. Department of Defense/NAVSTAR
GPS satellites, the OmniSTAR correction service or the WAAS correction
service.
Raven Industries accepts no responsibility for the use of the signal for other than
the stated purpose. Raven Industries shall not be responsible or liable for
incidental or consequential damages or a loss of anticipated benefits or profits,
work stoppage or loss or impairment of data arising out of the use, or inability to
use, the SmarTrax or any of its components.
CHAPTER
INTRODUCTION
1
Congratulations on your purchase of the Raven AccuBoom system! This
system is designed to provide worry-free turn on and turn off of the booms
with respect the as-applied coverage map. The instructions in this manual
are designed to assist you in the proper installation of the AccuBoom
system. Refer to your console-specific Installation and Operation manual
for instructions on setting up the software and using the AccuBoom
system.
Important! All boom switches must remain in the ON

position while AccuBoom control is in operation!
Components Needed for this Procedure
CAN AccuBoom Control Node (P/N 063-0172-316)

Case 3320/3330/4420 CAN AccuBoom Cable (P/N 115-0171-688)
Case SPX 3320/3330/4420 Sprayer CAN Installation Manual (P/N 016-
0171-084)
1 CaseIH SPX 3320/3330/4420 Sprayer

20 Series FLX (Liquid Bed)
Notes:
Manual No. 016-0171-084 2

CHAPTER
INSTALLATION
2
Complete the following steps to properly install the AccuBoom on a
CaseIH SPX 3320/3330/4420 Series Sprayer or a CaseIH FLX 20 Series
Liquid Floater.
Mount the CAN AccuBoom Node Behind the Operator Cab
1. Find the Case boom cable connector (12-pin Deutsch) located directly
behind the cab.
2. Find the mounting studs (if equipped) located on the cross member
below the cab.
Figure 1: CAN AccuBoom Node Installed (Model Year 2008 & Newer)
AccuBoom
Node
Important! Some earlier model machines (2007 and

older) may not have these mounting studs factory
installed. If they are not, add these studs or choose a
suitable mounting location.

3. Mount the CAN AccuBoom node (P/N 063-0172-316) on the mounting
studs (if supplied).
Figure 2: CAN AccuBoom Node Installed (Model Year 2007 & Older)
AccuBoom
Node
Connect the AccuBoom Cable to the AccuBoom Node

1. Connect the two Cinch rectangular connectors on the AccuBoom cable
(P/N 115-0171-688) to the CAN AccuBoom Node (P/N 063-0172-316).
Figure 3: AccuBoom Cable Connected to the Node
AccuBoom
Harness
Connection
Manual No. 016-0171-084 4

Connect the AccuBoom Cable to the Sprayer Boom
Harness
1. Unplug the 12-pin Deutsch boom connector located behind the

operator cab.
2. Plug the AccuBoom cable (P/N 115-0171-688) 12-pin Deutsch
connector into the corresponding boom connector.
Figure 4: Boom Connection
Boom
Connection
Connect the AccuBoom Node to the CAN System

1. Locate the sprayer CAN connector located close to the spray boom
connector.
2. Remove the CAN terminator from the sprayer CAN connector.
3. Connect the AccuBoom cable (P/N 115-0171-688) to the CAN connection.
4. Connect the previously removed terminator into the other CAN
connector on the AccuBoom cable (P/N 115-0171-688).
Figure 5: CAN Connection
CAN
Connector

Connect Power and Ground
1. Connect the red power wire from the AccuBoom cable (P/N 115-0171-
688) to a source of battery power.
2. Connect the white ground wire from the AccuBoom cable (P/N 115-
0171-688) to battery ground.
3. Model Year 2008 & Newer Only Connect the logic power 2-pin
Deutsch connector to the machines 2-pin Deutsch connector labeled
Controller Power.
Model Year 2007 & Older Only Connect the logic power 2-pin
Deutsch connector to the source of switched power.
Figure 6: Logic Power Connection at the Rear of the Cab
Manual No. 016-0171-084 6

CHAPTER
SYSTEM TROUBLESHOOTING
3
The CAN AccuBoom node (P/N 063-0172-316) has additional features to
allow the user to diagnose the AccuBoom system. The CAN AccuBoom
node has a plastic window in the case that allows the user to view green
diagnostic lights. The following picture shows the positioning and function
of each of the LED lights.
Logic Power
Micro 1 Hz
CAN Rx
CAN Tx
High Current
Power (HC)
Logic Power Lit when 12 VDC logic power is available at the node.
Micro 1Hz Flashes at 1 Hz interval when the processor is active.
CAN Rx Flashes when CAN messages are being received.
CAN Tx Flashes when CAN messages are being transmitted.
High Current Power Lit when high current power is applied to the
node.

RAVEN INDUSTRIES
Limited Warranty
What Does this Warranty Cover?
This warranty covers all defects in workmanship or materials in your
Raven Applied Technology Product under normal use, maintenance,
and service.
How Long is the Coverage Period?

Raven Applied Technology Products are covered by this warranty for
12 months after the date of purchase. This warranty coverage applies
only to the original owner and is nontransferable.
How Can I Get Service?

Bring the defective part and proof of purchase to your Raven Dealer.
If your Dealer agrees with the warranty claim, the Dealer will send the
part and proof of purchase to their distributor or to Raven Industries
for final approval.
What Will Raven Industries Do?

Upon confirmation of the warranty claim, Raven Industries will, at our
discretion, repair or replace the defective part and pay for return
freight.
What is not Covered by this Warranty?

Raven Industries will not assume any expense or liability for repairs
made outside our facilities without written consent. Raven Industries
is not responsible for damage to any associated equipment or
products and will not be liable for loss of profit or other special
damages. The obligation of this warranty is in lieu of all other
warranties, expressed or implied, and no person or organization is
authorized to assume any liability for Raven Industries.
Damages caused by normal wear and tear, misuse, abuse, neglect,

accident, or improper installation and maintenance are not covered
by this warranty.

016-0171-084F - AccuBoom - Case IH SPX 3320-3330-4420 Sprayer and 20 Series FLX Liquid Bed - Installation Manual

Uploaded by

Copyright:

Available Formats

016-0171-084F - AccuBoom - Case IH SPX 3320-3330-4420 Sprayer and 20 Series FLX Liquid Bed - Installation Manual

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

016-0171-084F - AccuBoom - Case IH SPX 3320-3330-4420 Sprayer and 20 Series FLX Liquid Bed - Installation Manual

Uploaded by

Copyright:

Available Formats

Case IH SPX 3320/3330/4420

Sprayer and 20 Series FLX (Liquid

P/N 016-0171-084 Rev C 12/15

Copyright 2009, 2015

Raven Industries cannot guarantee the accuracy, integrity, continuity, or

Important! All boom switches must remain in the ON

Components Needed for this Procedure

CAN AccuBoom Control Node (P/N 063-0172-316)

1 CaseIH SPX 3320/3330/4420 Sprayer

Manual No. 016-0171-084 2

Mount the CAN AccuBoom Node Behind the Operator Cab

Important! Some earlier model machines (2007 and

3 CaseIH SPX 3320/3330/4420 Sprayer

Connect the AccuBoom Cable to the AccuBoom Node

Figure 3: AccuBoom Cable Connected to the Node

Manual No. 016-0171-084 4

1. Unplug the 12-pin Deutsch boom connector located behind the

Figure 4: Boom Connection

Connect the AccuBoom Node to the CAN System

Figure 5: CAN Connection

5 CaseIH SPX 3320/3330/4420 Sprayer

Figure 6: Logic Power Connection at the Rear of the Cab

Manual No. 016-0171-084 6

7 CaseIH SPX 3320/3330/4420 Sprayer

How Long is the Coverage Period?

How Can I Get Service?

What Will Raven Industries Do?

What is not Covered by this Warranty?

Damages caused by normal wear and tear, misuse, abuse, neglect,

You might also like