Scribd
Upload
222 views1 page

Fall Arresters

Tracespec Global Resources Ltd provides fall arrester inspection checklists according to BS 5062:1985 and DIN 23-326 standards. The 7-point checklist examines key components like the safe working load, identification markings, body casting, spring retraction, cable condition, locking mechanism, and connecting hardware for damage, wear, or need for repair. Inspectors sign off with any general observations after conducting a thorough safety inspection.

Uploaded by

Trust Emma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
222 views1 page

Fall Arresters

Tracespec Global Resources Ltd provides fall arrester inspection checklists according to BS 5062:1985 and DIN 23-326 standards. The 7-point checklist examines key components like the safe working load, identification markings, body casting, spring retraction, cable condition, locking mechanism, and connecting hardware for damage, wear, or need for repair. Inspectors sign off with any general observations after conducting a thorough safety inspection.

Uploaded by

Trust Emma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TRACESPEC GLOBAL RESOURCES LTD

48 NKPOGU ROAD, TRANS AMADI INDUSTRIAL LAYOUT, PORT HARCOURT, RIVERS STATE.
08032357998, 08167338884, email: [email protected], [email protected]

FALL ARRESTERS INSPECTION CHECKLIST


BS 5062:1985 / DIN 23-326

Key: 1 = Satisfactory 2= Needs Attention 3 = Needs Repair

Condition
S/N Description of Activities Remarks
1 2 3
1 Check: SWL, Mark, ID No and inspection Colour code.
Check Certificate of Warranty and Material Identity or State of
2
Conformity.

Check the body casting for damage, distortion, cracks and any
3 abnormalities. Ensure there are no gaps between the two body
sections. Check also that all screws are present and fully tight.

Check spring retraction. The galvanized steel and cable should


4
retract the complete length of the cable.
Check entire length of cable for abrasions, kinking, corrosion and
5
broken wires.

6 Check lock on action by pulling sharply on the end of the cable.

Check D-rings, snap hooks and automatic locking hooks for


7 damage and distortion. Check also for cracks worn parts and sharp
edges.

General Observations and Remarks

Signature
Company Appointed Examiner

Name:

You might also like