Scribd
Upload
2K views1 page

Beam Clamp

The document is a beam clamp inspection checklist that provides instructions to inspect beam clamps according to BS EN 13157 standards. It lists 7 key inspection points to check the beam clamps for signs of wear, damage, corrosion and proper functioning. These include checking identification markings, certificates of conformity, the clamp halves and jaws for distortions or damage, screw threads, spigots and handles. The checklist also includes spaces to record the condition and remarks for each inspection point.

Uploaded by

Trust Emma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Beam Clamp

The document is a beam clamp inspection checklist that provides instructions to inspect beam clamps according to BS EN 13157 standards. It lists 7 key inspection points to check the beam clamps for signs of wear, damage, corrosion and proper functioning. These include checking identification markings, certificates of conformity, the clamp halves and jaws for distortions or damage, screw threads, spigots and handles. The checklist also includes spaces to record the condition and remarks for each inspection point.

Uploaded by

Trust Emma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TRACESPEC GLOBAL RESOURCES LTD

48 NKPOGU ROAD, TRANS AMADI INDUSTRIAL LAYOUT, PORT HARCOURT, RIVERS STATE.
08032357998, 08167338884, email: [email protected], [email protected]

BEAM CLAMPS INSPECTION CHECKLIST


BS EN 13157

Key: 1 = Satisfactory 2= Needs Attention 3 = Needs Repair

Condition
S/N Description of Activities Remarks
1 2 3
1 Check: SWL, Mark, ID No and inspection Colour code.
2 Check Test Certificate or State of Conformity.

Examine beam clamp thoroughly for wear damage and corrosion,


3
especially at hinge points and shackle attachment point.

Check inner and outer clamp halves for wear, damage and
4
distortion.
Check jaws for damage and distortion. Swivel type must be move
5
freely.
Checks were applicable that screw thread is in good condition, is
6
not bent and screws in and out freely.

7 Check that screwed spigots are not worn or distorted.

8 Check tommy bar handle for damage and distortion.

General Observations and Remarks

Signature
Company Appointed Examiner

Name:

You might also like