Scribd
Upload
427 views2 pages

5335 Device Firmware Reload

The document provides instructions for reloading firmware on a device using a USB flash drive. It involves 7 steps: 1) preparing the USB drive with the firmware file, 2) starting the upgrade by powering off the device and inserting the USB drive, 3) initiating the download process, 4) finishing the download process and rebooting the device, 5) checking that the new firmware version is displayed, 6) powering off and removing the USB drive, and 7) powering back on and confirming the new firmware version.

Uploaded by

Luis Gon Ram
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
427 views2 pages

5335 Device Firmware Reload

The document provides instructions for reloading firmware on a device using a USB flash drive. It involves 7 steps: 1) preparing the USB drive with the firmware file, 2) starting the upgrade by powering off the device and inserting the USB drive, 3) initiating the download process, 4) finishing the download process and rebooting the device, 5) checking that the new firmware version is displayed, 6) powering off and removing the USB drive, and 7) powering back on and confirming the new firmware version.

Uploaded by

Luis Gon Ram
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

5335 device firmware reload.

(altboot equivalent)

use USB flash drive from device tray 1 compartment,

should be labelled with VER 53.03.51

1. Prepare a USB Flash Drive

a. Ensure that the USB device to be used has sufficient free space to
contain the files to be downloaded.

b. Create a new folder in the USB Flash Drive and name it DWLD.

c. Copy the software file(s) obtained in Step 1 (unzip the file and
extract the .bin file if required) into the DWLD folder.

2. Start Upgrade

a. Power OFF the machine.

NOTE:

if USB Printing is enabled, the USB port on the Control Panel can be
used.

b. Insert the USB Flash Drive into the USB connector on the Control
Panel (if available) or the ESS PWB Chassis.

The FAX Cable (if present) should remain plugged in during the SW
upgrade. This enables the FAX software to be upgraded using this
procedure.

3. Start the download

a. Power ON the machine while pressing the Energy Saver button.


Hold the button down until Download Mode appears.

b. After a while, Transferring will be displayed on the UI and the S/W


will start to download to the machine. If Transferring is not displayed
after 3 minutes, there is a problem either with the USB Device or
with the USB port. Make sure the Flash Drive is plugged in all the
way. Repeat the procedure with a different USB device.
4. Finish the Download

a. While the download is in progress, Processing X / Y (where X is the


module being loaded, and Y is the total number of modules) is
displayed on the UI to show the progress of the download.

b. When the download is complete, the machine will reboot


automatically.

5. Check

a. After the automatic reboot, a progress bar will be displayed on the


UI and the machine will return to the ready state.

b. Press the Machine Status button.

c. Select General Information.

d. Select Software Version.

e. Verify that the just-downloaded software version is displayed. If the


previous version is still displayed, there may be a problem with the
USB Flash Drive. Repeat the procedure with a different device.

6. Power OFF

a. Power OFF the machine and remove the USB Flash Drive.

7. Power on device , print configuration page, confirm DHCP ip address

You might also like