Thermo2 Mid
Thermo2 Mid
Thermo2 Mid
I f the temperature of saturated water is increased infinitesimally at constant entropy, the resulting
state of water will be
a. Liquid b. Liquid vapor coexistence c. Saturated vapor d. Solid
2. I n a parallel flow heat exchanger operating under steady state, hot liquid enters at a temperature T h,in
and leaves at a temperature T h,out . Cold liquid enters at a temperature T c,in and leaves at a temperature
T c,out . Neglect any heat loss from the heat exchanger to the surrounding. If T h,in >> T c,in , then for a
given time interval, which ONE of the following statements is true?
a. Entropy gained by the cold stream is GREATER than entropy lost by the hot stream
b. Entropy gained by the cold stream is EQUAL to the entropy lost by the hot stream
c. Entropy gained by the cold stream is LESS than the entropy lost by the hot stream
d. Entropy gained by the cold stream is ZERO
4. In a process occurring in a closed system F, the heat transferred from F to the surroundings E is 600 J.
If the temperature of E is 300 K and that of F is in the range 380 - 400 K, the entropy changes of the
surroundings (SE) and system (SF), in J/K, are given by
a. SE = 2, SF = -2 b. SE = -2, SF = 2 c. SE = 2, SF < -2 d. SE = 2, SF > -2
7. How is internal energy related to temperature, pressure, and changes in both volume and
entropy of a system?
a. dU = PdV - TdS b. dU = PdS - TdV c. dU = TdS - PdV d. dU =TdS + PdV
8. A saturated liquid at 1500 kPa and 500 K, with an enthalpy of 750 kJ/kg, is throttled to a
liquid-vapor mixture at 150 kPa and 300 K. At the exit conditions, the enthalpy of saturated
liquid is 500 kJ/kg and the enthalpy of saturated vapor is 2500 kJ/kg. The percentage of the
original liquid, which vaporizes is
a. 87.5% b. 67% c. 12.5% d. 10%
9. The state of an ideal gas is changed from (T 1, P1) to (T2, P2) in a constant volume process. To
calculate the change in enthalpy, all of the following properties or variables are required.
a. CV, P1, P2 b. CP, T1, T2 c. CP, T1, T2, P1, P2 d. CV, P1, P2, T1, T2
10. For a pure substance, the Maxwells relation obtained from the fundamental property relation
dU = TdS PdV is
a. ( VT ) =( PS )
S V
b. ( PT ) =( V S )
V T
c. ( TP ) =( VS )
S P
d.
( VT ) =( PS )
P T
11. 2 kg of steam in a piston cylinder device at 400 kPa and 175 0C undergoes a mechanically
reversible, isothermal compression to a final pressure such that the steam becomes just saturated.
What is the work, W, required for the process.
Data:
T = 1750C P = 400 kPa V = 0.503 m3/kg U = 2606 kJ/kg S = 7.055 kJ/kg-K
0 3
T = 175 C Satd. vapor V = 0.216 m /kg U = 2579 kJ/kg S = 6.622 kJ/kg-K
a. 0 kJ b. 230 kJ c. 334 kJ d. 388 kJ
U
=(
P ) H
14. Which of the following equation is obtained on combining 1st and 2nd law of
thermodynamics, for a system of constant mass?
a. dU = TdS PdV b. dQ = CvdT + PdV c. dQ = CpdT + VdP d. TdS = dU PdV
a. G= H +T T [
( F )
P
] c. d (U TS ) T ,V <0
dP H vap
b. G= HT T d. =
dT T V vap
17. Critical temperature is defined as the temperature above which a gas will
a. not liquefy (barring exceptions) c. never liquefy however high the pressure may be
b. immediately liquefy d. none of these
18. If two gases have same reduced temperature and reduced pressure, will have the same
a. volume b. mass c. critical temperature d. none of these
19. When a gas is expanded from high pressure region to low pressure region; temperature
change occurs. This phenomenon is related with
a. Gibbs-Duhem equation c. Gibbs-Helmholtz equation
b. Third law of thermodynamics d. Joule-Thomson effect
10. For an incompressible fluid, ____ is a function of both pressure as well as temperature.
a. internal energy b. enthalpy c. entropy d. all a, b and c
A nozzle expands air isentropically from 400 C and 2 MPa to the atmosphere
at 80 kPa. If the inlet velocity is small, what exit velocity (m/s) can be
expected?
a. 500 b. 600 c. 900
d. 1200
5. Which of the following types of flow indicates that the Mach number is
equal to 1?
a. subsonic b. sonic c. supersonic d.
hypersonic
7-8. Air at 100 kPa and 280K is compressed steadily to 600 kPa and 400 K.
The mass flow rate of the air is 0.02 kg/s and a heat loss of 16 kJ/kg occurs
during the process. Assuming the changes in kinetic and potential energies
are negligible, determine the necessary power input in kW to the
compressor.
a. 0.81 b. 1.56 c. 2.73
d. 3.29
9-10. Steam at 200 psia and 600 0F (state 1) enters a turbine through a
standard 3-in pipeline with a velocity of 10 ft/s. The exhaust from the turbine
is carried through a standard 10-in pipeline and is at 4 psia and 160 0F (state
2). H1 = 1,321.4 BTU/lb, V1 = 3.059 ft3/lb, H2 = 1,129.3 BTU/lb, V2 = 92.15
ft3/lb. What is the power output of the turbine in hp, assuming no heat losses.
a. 40.2 b. 43.1 c. 45.6
d. 47.5