Scribd
Upload
50 views3 pages

Firmware Update Guide

This firmware update guide requires erasing all user data on a tablet and using an empty microSD card of at least 2GB in a single-slot card reader to recover the tablet's firmware. The process involves unpacking firmware files, using a PhoenixCard tool to burn the firmware image file to the microSD card, inserting the card into the tablet to start the update, removing and reinserting the card to format it for normal use.

Uploaded by

Deni Gadaric
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
50 views3 pages

Firmware Update Guide

This firmware update guide requires erasing all user data on a tablet and using an empty microSD card of at least 2GB in a single-slot card reader to recover the tablet's firmware. The process involves unpacking firmware files, using a PhoenixCard tool to burn the firmware image file to the microSD card, inserting the card into the tablet to start the update, removing and reinserting the card to format it for normal use.

Uploaded by

Deni Gadaric
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Firmware Update Guide

Important
Please note that this update method should be used only for tablet recovery. All
user data on the tablet would be erased. For this operation you will need one empty
microSD card not less than 2Gb and card reader device with ONLY one card slot.
Multifunctional card readers with more than one card interfaces are NOT allowed.

1. Unpack archive content to the separate folder. Youll get two


folders Firmware and PhoenixCard Tool

2. Go to the PhoenixCard Tool folder and launch PhoenixCard(


)
3. Choose right disk letter for the SD card, then press Img File
button and choose *.img file from the unpacked archive.

4. Click Burn button

5. After burn process would be finished remove card from the


card reader and plug it into the tablet.
6. Restart the tablet with card plugged. You will hear clicking
sounds it means that update process started. Wait while
progress bar becomes fully green and clicking sounds
disappeared.
7. Remove SD card and restart the tablet.
8. To make card fully usable please plug it into the card reader
again, launch PhoenixCard utility and press Format to
Normal button.

You might also like