> Avionics CNI > Military & Space > Professional Communications

PUMA T3-plus

The latest Dual Mode TETRA Handheld from SELEX Communications the PUMA
T3-plus is a high performance and top quality hand set designed for users relying
on mission critical communications

OVERVIEW GPS Location Service

PUMA T3-plus is the latest SELEX Communications Dual Mode The Puma T3 Plus incorporates the latest GPS technology to
TETRA handheld developed on the basis of answering real offer best accuracy in the acquisition of the users location.
users' requirements. The single chip GPS Location service provides an efficient use
Its rich set of features and new functions offer a complete set of terminal resources and a low current consumption.
of TETRA services to satisfy the highest demands of professional The transmission protocol of the location data over the air-
users. The lightweight aluminium alloy case with reinforced interface is in accordance with the ETSI LIP standard.
rotary knob and antenna connector result in the most rugged
and durable design available on the market.
Ergonomics
NEW FEATURES Unlike most TETRA radios available on the market, the PUMA
T3-plus is designed to provide the best ergonomics of use.
Colour Graphic Display
The keypad and all function keys are of adequate size and
The PUMA T3-plus includes a new, high resolution, colour spacing to be easily used, even when wearing gloves.
graphic display that assures excellent visibility in all lighting
conditions.
The PUMA T3-plus provides easy and intuitive navigation menus Flexible Connectivity of Accessories
for rapid access to all the TETRA functions, and customization The PUMA T3-plus allows the connection of audio and data
features such as setting the font size. accessories in three different ways:
 Built in Bluetooth interface for wireless connection of
commercial Bluetooth voice and data devices.
Industrial standard USB type B socket located on the right
side of the equipment for the connection of commercial light
ear bud, travel charger and data cable.
A traditional rugged IP54 protected connector located at the
bottom side for interfacing high quality SELEX
Communications accessories. Accessories from the previous
PUMA T3 version can be used with the PUMA T3-plus.

Audio
PUMA T3-plus's new 1W loudspeaker, together with the high
power audio amplifier, supplies an undistorted high quality
audio signal to guarantee intelligibility in all environmental
conditions.

MAIN FUNCTIONALITIES
Multislot operations
The PUMA T3-plus provides for multi-slot data transmission up
to 4 slots, allowing the maximum TETRA data rate capacity, to
support a wide range of data applications such as file transfer,
database interrogation and image transmission, both in circuit
and IP packet data mode.
Simultaneous Voice and Data transmission can be carried out
using different timeslots.

Secure Communications
In order to protect the critical speech and/or data
communications from potential eavesdroppers PUMA-T3-plus,
in TETRA mode supports a high degree of communication
security through adoption of: Authentication, dynamic key Air
Interface encryption, and End-to-End encryption. Beside the
TETRA standard E2E encryption, user specific algorithms for
E2E encryption can be supported.

Man-down switch
PUMA T3-plus is equipped with an internal "Man-down" switch
that allows detection of the angle between the longitudinal axis
of the radio and the vertical axis. The radio can be configured
to send a message or to launch automatically a predefined call Broadcast calls
in case of a man-down detection.
Priority and Emergency calls
PABX, PSTN, PDN Interconnection
Dual Mode Direct Mode Operation (also with Repeater and Gateway)
PUMA T3-plus is the only TETRA hand-set on the market that Short Data Service (status/text messages)
can also operate as conventional FM radio equipment. The Localization Services
PUMA T3-plus can be instantly switched between conventional End-to-End Encryption
analogue and TETRA mode. This ability together with the TETRA Supplementary Services
extended switching band-width of the PUMA T3-plus allow a
Up to 4 time slots transmission data calls
soft migration from analogue UHF to TETRA services and
interoperability with legacy technology. Single and multi slot Circuit Data services
Single and multi slot IP Packet Data services
The main features supported in conventional analogue mode
are: Dynamic key "Air interface Encryption"
Man-down switch
Channel spacing of 12.5 kHz and 25 kHz
CTCSS tone squelch
Data storage capacity
Selective calls according to CCIR, ZVEI standard
Simplex or semi-duplex operation. 1472 TMO/DMO talk groups
1000 static entries in the phone directory
SELECTION OF THE MAIN SUPPORTED TETRA FEATURES 200 phone book entries
10 predefined or user defined text messages
Individual calls
72 predefined status messages
Group calls
20 recent individual calls
Emergency calls
20 recent received messages.
ACCESSORIES TECHNICAL CHARACTERISTICS
Travel chargers (wall and car charger) Frequency band: 380 to 430 MHz and 410 to 470 MHz
Desktop charger Functional modes: Trunk Mode, Direct Mode, DMO with Repeater
Wired and wireless audio accessories 1A and GW
Throat microphone and speaker Data rate (max): up to 28.8 kbps
Programming kit RX static sensitivity: -112 dBm ( typical -114 dBm)
Leather carry case RX dynamic sensitivity: -103 dBm ( typical -105 dBm)
1/4 wave antenna for extended range RF channel spacing: 25 kHz & 12.5 kHz in FM
PEI connection kit for data transmission Duplex spacing: 10 MHz
Audio max power: 1 W @ 4 Ohm
Power class: 4 (1 W nominal) ETSI EN 300 392-2/396-2
Receiver class: ETSI EN 392-2/396-2 class A + B
SIM card: Supported
Neckband headset
Antenna connector: 50 Ohm
Lightweight and rugged Battery duration: About 16 hours @ 5/35/60 duty cycle (*)
headset with noise cancelling
Power supply: Li-Ion 2500 mAh, 3.7V
microphone.
Dimensions & weight: (HxWxD) 134 x 61 x 33.5 mm, 305 g. (with battery)
ATEX certified 2G EEx ib IIC Air Interface protocol: - TETRA V+D MS (EN 300 392-2)
T4. - TETRA DM MS (EN 300 396-3)
- Air Interface Encryption ( TEA 1-2)
- E2E encryption
FM-mode Radio spec: EN 300 086
Supp. signalling: CTCSS, CCIR, ZVEI 1&2
Throat microphone and Electrical specifications: ETSI EN 300 392-2
speaker EMC specifications: ETSI EN 301 489-18, EN 301 489-5
Hands-free kit for use with Data terminal interface: TETRA Peripheral Equip. I/F (EN 300 392-5)
protective masks (e.g. gas or
oxigen) and clothes. (*) note that the battery duration depends on received signal strength, volume level, use of
the display and the backlighted keypad.
ATEX certified 2G EEx ib IIC
T4.
User devices
Keys: PTT key, pre-defined call key, emergency call key, 6
function/navigation keys, telephonic standard keypad
Rotary knob: for group selection and audio volume
Display: Color backlighted graphic displayable to display three
Large PTT
lines of 11 characters rec. Schengen icon. resolution of
Wired PTT for audio 128x96 pixel with over 65.000 colours
accessories connection. Connectors: - one for professional accessories (IP54)
ATEX certified 2G EEx ib IIC - one USB type B for light headset, travel charger and
T4. data cable
Built-in single 12 channels
chip GPS -152 dBm acquisition sensitivity
Desktop charger receipt: -152 dBm tracking sensitivity
Two slot, one for PUMA T3- max accuracy 10m
plus and one for spare
battery.
110-220V AC EU or UK
plug;
12-24V DC car cigarette
lighter plug

Multiple desktop charger

Three slot for spare batteries
and three slot for PUMA T3-
plus.
110-220V AC EU, UK and
USA plug.
Environmental specifications
Climatic condition: ETSI EN 300 019-1-7 Class 7.3
(-25 to +70C)
Conformance testing
specifications for TETRA
equipment: ETSI EN 300 394-1 (-20 to +55 C)
Water and Dust protection: IEC 529 class IP54
Mechanical conditions: - ETSI EN 300 019-1-7 & IEC 721-3-7 class
7M3
- MIL STD 810 E/F - Method 516.4/5,
procedures I/IV/V
- MIL STD 810 E/F - Method 514.4/5,
procedure I, category 20 (Vibration Tests
for U.S. highway truck transportation and
composite wheeled vehicle transp.).
- EN 60068-2-32 - Free fall 1 m. height on
concrete surface
Transportation Temperature: ETSI EN 300 019-1-2 class 2.3

Copyright 2007 SELEX Communications SpA - All rights reserved.

This publication is issued to provide outline information only which (unless agreed by SELEX Communications
SpA in writing) may not be used, applied or reproduced for any purpose or form part of any order or contract or
be regarded as a representation relating to the products or services concerned. SELEX Communications SpA
reserves the right to alter without notice the specification, design or conditions of supply of any product or service.
e-mail: [email protected] www.selex-comms.com SELEX Communications logo is a trademark of SELEX Communications SpA.
Printed in Italy. e-P-IT-xxx/V1/07/Y