ICC-ES Report: Tileable Shower Kit
ICC-ES Report: Tileable Shower Kit
ICC-ES Report: Tileable Shower Kit
Reissued 08/2016
This report is subject to renewal 08/2017
EVALUATION SUBJECT:
DIVISION:
09 00 00FINISHES
SECTION:
09 30 00TILING
Report Holder:
VIM PRODUCTS
5060 TRADEMARK DRIVE
RALEIGH, NC 27610
ICC-ES PMG Listing PMG-1094
Effective Date: August 2016
This listing is subject to re-examination in one year.
www.icc-es-pmg.org | (800) 423-6587 | (562) 699-0543 A Subsidiary of the International Code Council
DIVISION: 09 00 00 FINISHES
Section: 09 30 00 Tiling
The ICC-ES product certification system includes testing samples taken from the market or suppliers
stock, or a combination of both, to verify compliance with applicable codes and standards. The
system also involves factory inspections, and assessment and surveillance of the suppliers quality
system.
ANSI A 118.10-2014, Specification for Load Bearing, Bonded, Waterproof Membranes for Thin-Set
Ceramic Tile and Dimension Stone Installation.
LC1030-2011 PMG Listing Criteria for Prefabricated, Tileable Shower Receptor
ASME A112.18.2/CSA B125.2-2015, Plumbing Waste Fittings
Identification:
6048-LES Tileable Shower Kit described in this listing must be identified by a stamp bearing the
manufacturers name or trademark, the model number and the ICC-ES PMG listing mark.
Listings are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed as an
endorsement of the subject of the listing or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as to
any finding or other matter in this listing, or as to any product covered by the listing.
Copyright 2016 ICC Evaluation Service, LLC. All rights reserved. Page 1 of 2
PMG-1094 | Most Widely Accepted and Trusted Page 2 of 2
Installation:
Each Tileable Shower Kit must be installed in accordance with the manufacturers published
instructions and the applicable codes.
The Tileable Shower Kit surfaces to be covered shall be smooth and free of irregularities that would
make installation covering uneven. The size and slope shall conform to the requirements of the latest
editions of the International Plumbing Code, International Residential Code and Uniform Plumbing
Code. Provision shall exist to allow movement of water along the prefabricated, tilable shower
receptor into drain.
The Shower Lining membrane shall conform to ANSI A118.10 and shall have a current listing with an
approved third-party certification agency. Provisions shall exist to allow movement of water along the
shower lining membrane into the drain. Attachment of the membrane to the shower kit, in the field,
shall be made in accordance with the manufacturers published installation instructions.
The shower drain shall conform to the applicable material and performance requirements in ASME
A112.18.2/CSA B125.2 and shall have a current listing with an approved third-party certification
agency. Attachment of the drain to the receptor, in the field, shall be made in accordance with the
manufacturers published installation instructions.
Models:
Conditions of Listing: