Article1404395371 - Shibu and Rajan

Vol. 6(4), pp.
36-38, June 2014

DOI: 10.5897/JDOH2014.0118
Article Number:9461FCE45814
ISSN 2006-9871
Copyright 2014
Author(s) retain the copyright of this article
http://www.academicjournals.org/JDOH
Journal of Dentistry and

Oral Hygiene
Short Communication
Minimally invasive endodontics

Shibu Thomas Mathew1* and Julie Susan Rajan2
1
Department of Endodontics, Riyadh Colleges of Dentistry and Pharmacy, Riyadh, Kingdom of Saudi Arabia.
2
Department of Preparatory Health Sciences, Riyadh Colleges of Dentistry and Pharmacy, Riyadh,
Kingdom of Saudi Arabia.
Received 2 June, 2014; Accepted 17 June, 2014
The primary goal of endodontic therapy is the long-term retention of a functional tooth by preventing or
treating apical periodontitis. However, there are many other factors that impact endodontic outcomes
such as the quality of the restoration and structural integrity of the tooth after root canal preparation.
Contemporary research efforts are currently directed to better understanding dentine behaviour and
structure during aging and function. An alternative approach is to minimize structural changes during
root canal therapy, which may result in a new strategy that can be labeled 'minimally invasive
endodontics'. This paper focuses on describing minimally invasive dentistry in endodontics from a
conceptual perspective, relating to diagnosis, access opening, instrumentation and obturation of the
root canal system.
Key words: Minimally invasive dentistry, caries removal, pulpal diagnosis, periapical diagnosis, gouging.
INTRODUCTION
Minimal invasive dentistry (MID) can be defined as
maximal preservation of healthy dental structures
(Ericson, 2007). This is a concept that can embrace all
the aspects of the profession. The main goal is tissue
preservation, preferably by preventing diseases from
occurring and intercepting its progress, but also by
removing and replacing it with as little tissue loss as
possible. With regards to endodontic procedures, it
ranges from diagnosis to making a decision not to treat,
to a minimally but purposefully crafted access opening,
based on anatomical challenges, to minimal removal of
dentin during access opening, enlarging and shaping of
root canal to retain as much sound dentin as possible to
retention of tooth structure during disassembly and
retreatment or considering apical surgical intervention, to
perform a crown lengthening procedure to establish sound
tooth structure margins for core/crown restorations as

opposed to tooth extraction and implant or bridge
placement (Murdoch-Kinch and McLean, 2003;Nov and
Fuller, 2008).
DIAGNOSIS
Diagnosis of endodontic problems can be a challenging
part of treatment process. It can frustrate clinicians and
patients. Part of the difficulty is that it is not always a
black and white issue; there are many shades of gray
including subtle nuances in the patients history that must
be addressed when making treatment decisions (Tables1
and 2).
*Corresponding author. E-mail: [email protected]. Tel: 00966 509136903.

Author(s) agree that this article remain permanently open access under the terms of the Creative Commons Attribution
License 4.0 International License
Matthew and Rajan
37
Table 1. How the examination results correlate with the diagnosis.
Pulp diagnosis
Normal
Reversible pulpitis
EPT test results

Responsive
Responsive
Thermal test results

Sharp feeling to cold that subsides quickly
Sharp feeling to cold that may linger very slightly no throbbing or aching
Irreversible pulpitis
Responsive
Throbbing/aching/lingering pain with hot or cold, aching pain several

minutes after stimulus is removed
Necrotic
No response
No response
Table 2. How the examination results correlate with the periapical diagnosis.
Periapical diagnosis
Normal
Acute periradicular periodontitis
Chronic periradicular periodontitis
Chronic periradicular periodontitis with symptoms
Suppurative periradicular periodontitis
Acute periradicular periodontitis
Radiographic
No lesions
No lesions
Lesion
Lesion
Lesion, sinus tract
Lesion/No lesion
Figure 1. Gouging.
Access opening
Knowledge of anatomical structures and its variations is
essential, so that from caries removal to root canal
enlargement, sound tooth structure should be preserved;
especially important is the prevention of gouging
cervically laterally or into the floor of pulp chamber
(Figure 1) (Gutmann, 2013).
Endo access has been performed which gives good
access to canal orifice, but imagine the thickness of
dentin that will remain mesially and distally if a crown was
Percussion
Not sensitive
Sensitive
Not sensitive
Sensitive
May/May not be sensitive
Sensitive
Palpation
Not sensitive
Not sensitive
Sensitive/Swelling
prepared for this tooth (Ericson and Kidd, 2003). The

endodontics has been perfectly performed but the tooth is
compromised due to excessive loss of tooth structure
during access. This is why we keep access limited and
you will see sometimes what appears to be incomplete
opening of pulp chamber. This is by design and allows
important tooth structure to be maintained that
contributes to the strength and durability of tooth.
Limiting tooth destruction becomes a greater challenge
when attempting to treat teeth with calcified pulp
chambers or canals. Assessing the degree of calcification
prior to attempting treatment is the key to preventing
iatrogenic damage to the teeth. One important aspect of
learning to limit the removal of healthy tooth structure for
access is that it actually makes endodontic procedures
much more difficult (especially in second and third
molars) and increases the chances of missing canals, so
you need to balance these potential issues with benefits
of doing so. Among the objectives of access opening, the
point of conservation of tooth structure need to be over
emphasized than the other major objectives like,
obtaining straight line access, identification of orifices and
de-roofing the pulp chamber.
ROOT CANAL INSTRUMENTATION

Even though judicious orifice location and careful canal
preparation are essential, efforts should be made to
minimize the excess removal of cervical tooth structure in
38
J. Dent. Oral Hyg.
the canal orifice through the sequential use and gates

glidden burs. A number of literature indicates that the
laws of tooth structure cervically weakens the tooth and
makes it susceptible to fracture. Even during widening
with gates glidden burs, it should not be placed deep into
the root canal as this tends to straighten the canal and
weaken the canal walls predisposing then to cracks,
stripping defects, etc.
The clinician has to carefully decide with which
instrument and how wide to shape a given canal to
achieve antimicrobial efficiency without weakening tooth
structure (Lertchirakaran et al., 1999).
Most NiTi
instruments used according to the current guidelines
allow wider shapes without major preparation errors and
without excessively reducing radicular walls. Remaining
dentin thickness was greater than 0.58 mm with GT
rotaries, profile and Hero. Earlier studies had indicated
considerable thinning of dentin walls after ultrasonic
instrumentation, predispose to vertical fracture. So it
would seem reasonable to develop better methods of
canal cleaning and disinfection that can be used in
presence of retained, sound tooth structure.
tooth together to resist both functional forces and

occlusal leakage.
CONCLUSION
Caution must be exercised when espousing the concepts
of MIE in that there are proponents that would have you
believe that MIE exists solely with the framework of
preserving a few millimeters or less of cervical tooth
structure while their empirical claims lack documented
and meaningful studies (Clark and Khademi, 2010; Clark
et al., 2013).
The long term treatment outcome can be measured visa-vis the extent of invasion. Less invasive procedure
generally would seem to provide for a greater degree of
predictability. On the other hand, it should be incumbent
on each practitioner to know the expected outcome for
any procedure, however invasive it may be.
Conflict of Interests
The author(s) have not declared any conflict of interests.
OBTURATION
Schilder suggested that the ideal root canal obturating
material should be well adapted along the entire length of
root canal walls and produce a homogenous mass.
Currently, with the application of adhesive dentistry in
endodontics, the present concept of obturation of root
canal is not just the 3-dimensional filling of root canal and
accessory canal, but also the reinforcement of root, also
known as mono block effect.
Vertical root fractures are complications that are mostly
seen in root canal obturated teeth and often lead to
extractions. This is mainly due to the force with which the
endodontic instrument (plugger, heater, spreader) is
applied to the tooths root canal during the endodontic
treatment.
According to (Piskin et al., 2008), the spreader size
larger than 25 number causes significant reduction in
fracture resistance of roots and another study by
Lertchirakarn et al. (1999) which state that fracture can
result from excessive lateral condensation forces during
root filling (Piskin et al., 2008; White and Eakle, 2000).
Only light pressure is required during lateral compaction
because the gutta-percha is not compressible and
because as little as 1.5 kg of pressure is capable of
fracturing the root. The use of strong well placed bonded
cone materials and a post (only when necessary) prior to
crown placement would help to tie the components of
REFERENCES
Clark D, Khademi J (2010). Modern molar endodontic access and
directed dentin conservation. Dent. Clin. North Am. 54(2):249273.
Clark D, Khademi J, Herbranson E (2013). Fracture resistant
endodontic and restorative preparations. Dent. Today 32(2):118, 120123.
Ericson D (2007). The concept of minimally invasive dentistry. Dent.
Update 34(1):9-10, 12-14, 17-18.
Ericson D, Kidd E (2003). Minimally invasive dentistry, concepts and
techniques in cariology. Oral Health Prev. Dent. 1:59-65.
Gutmann JL (2013). Minimal invasive dentistry (Endodontics). J.
Conserv. Dent. 16(4):282-283.
Lertchirakaran V, Palmara JE, Messer HH (1999). Load and strain
during lateral condensation and vertical root fracture. J. Endod.
25(2):99-104.
Murdoch-Kinch CA, McLean ME (2003). Minimally invasive dentistry. J.
Am. Dent. Assoc. 134(1):8795.
Nov BB, Fuller CE (2008). The material science of minimally invasive
esthetic restorations. Compend. Contin. Educ. Dent. 29(6):338-346.
Piskin B, Aydin B, Sarikanat M (2008). The effect of spreader size on
fracture resistance of maxillary incisors roots. Int. Endod J. 41(1):5459.
White JM, Eakle WS (2000). Rationale and treatment approach in
minimally invasive dentistry. J. Am. Dent. Assoc. 131(Suppl):13S19S.

Article1404395371 - Shibu and Rajan

Uploaded by

Copyright:

Available Formats

Article1404395371 - Shibu and Rajan

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Article1404395371 - Shibu and Rajan

Uploaded by

Copyright:

Available Formats

Vol. 6(4), pp.

36-38, June 2014

Journal of Dentistry and

Minimally invasive endodontics

tooth structure margins for core/crown restorations as

*Corresponding author. E-mail: [email protected]. Tel: 00966 509136903.

Matthew and Rajan

Table 1. How the examination results correlate with the diagnosis.

EPT test results

Thermal test results

Throbbing/aching/lingering pain with hot or cold, aching pain several

prepared for this tooth (Ericson and Kidd, 2003). The

ROOT CANAL INSTRUMENTATION

J. Dent. Oral Hyg.

the canal orifice through the sequential use and gates

tooth together to resist both functional forces and

You might also like