Scribd
Upload
40 views

Lab Assignment 2 PDF

This document outlines the requirements for an assignment on designing and simulating a buck-boost converter circuit. Students must design a buck-boost converter with an input voltage of 9V, output voltage of 12V, output current of 1.2A, switching frequency of 25KHz, voltage ripple of 270mV, and current ripple of 0.25A. Students must simulate the circuit and include printouts of the output voltage, output current, inductor ripple current, and capacitor voltage waveforms. They must also analyze whether the simulation results meet requirements and explain any discrepancies. The assignment is due on November 21, 2016 and late submissions will be penalized.

Uploaded by

NumanAbdullah
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
40 views

Lab Assignment 2 PDF

This document outlines the requirements for an assignment on designing and simulating a buck-boost converter circuit. Students must design a buck-boost converter with an input voltage of 9V, output voltage of 12V, output current of 1.2A, switching frequency of 25KHz, voltage ripple of 270mV, and current ripple of 0.25A. Students must simulate the circuit and include printouts of the output voltage, output current, inductor ripple current, and capacitor voltage waveforms. They must also analyze whether the simulation results meet requirements and explain any discrepancies. The assignment is due on November 21, 2016 and late submissions will be penalized.

Uploaded by

NumanAbdullah
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

COMSATS - Lancaster Dual Degree Programme

COMSATS Institute of Information Technology Lahore

Due Date: November 21, 2016


Total Marks = 10

Attempt all questions


Cheating is strongly prohibited. Disciplinary action would be taken against transgressors.
Late submission will inflict deduction of 5 marks per day.

Design a buck-boost converter circuit according to the following requirements and simulate it in the
simulation software of your choice.
= 9 , = 12 , = 1.2 , = 25 , = 270 , = 0.25
Display following waveforms and attach the print-outs with the submitted assignment

Output voltage waveform


Output current waveform
Inductor ripple current
Capacitor voltage current

See if the results obtained agree with the specified requirements. In case they dont, provide reasons
why it might be so.

You might also like