Nokia Siemens Networks

GSM/EDGE BSS, rel.

RG10(BSS), operating
documentation, issue 04

Key Map of Line Editor

DN985305
Issue 3-0

Key Map of Line Editor

The information in this document is subject to change without notice and describes only the
product defined in the introduction of this documentation. This documentation is intended for the
use of Nokia Siemens Networks customers only for the purposes of the agreement under which
the document is submitted, and no part of it may be used, reproduced, modified or transmitted
in any form or means without the prior written permission of Nokia Siemens Networks. The
documentation has been prepared to be used by professional and properly trained personnel,
and the customer assumes full responsibility when using it. Nokia Siemens Networks welcomes
customer comments as part of the process of continuous development and improvement of the
documentation.
The information or statements given in this documentation concerning the suitability, capacity,
or performance of the mentioned hardware or software products are given "as is" and all liability
arising in connection with such hardware or software products shall be defined conclusively and
finally in a separate agreement between Nokia Siemens Networks and the customer. However,
Nokia Siemens Networks has made all reasonable efforts to ensure that the instructions
contained in the document are adequate and free of material errors and omissions. Nokia
Siemens Networks will, if deemed necessary by Nokia Siemens Networks, explain issues which
may not be covered by the document.
Nokia Siemens Networks will correct errors in this documentation as soon as possible. IN NO
EVENT WILL Nokia Siemens Networks BE LIABLE FOR ERRORS IN THIS DOCUMENTATION OR FOR ANY DAMAGES, INCLUDING BUT NOT LIMITED TO SPECIAL, DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL OR ANY LOSSES, SUCH AS BUT NOT LIMITED
TO LOSS OF PROFIT, REVENUE, BUSINESS INTERRUPTION, BUSINESS OPPORTUNITY
OR DATA,THAT MAY ARISE FROM THE USE OF THIS DOCUMENT OR THE INFORMATION
IN IT.
This documentation and the product it describes are considered protected by copyrights and
other intellectual property rights according to the applicable laws.
The wave logo is a trademark of Nokia Siemens Networks Oy. Nokia is a registered trademark
of Nokia Corporation. Siemens is a registered trademark of Siemens AG.
Other product names mentioned in this document may be trademarks of their respective
owners, and they are mentioned for identification purposes only.
Copyright Nokia Siemens Networks 2009. All rights reserved

Important Notice on Product Safety

Elevated voltages are inevitably present at specific points in this electrical equipment.
Some of the parts may also have elevated operating temperatures.
Non-observance of these conditions and the safety instructions can result in personal
injury or in property damage.
Therefore, only trained and qualified personnel may install and maintain the system.
The system complies with the standard EN 60950 / IEC 60950. All equipment connected
has to comply with the applicable safety standards.

The same text in German:

Wichtiger Hinweis zur Produktsicherheit
In elektrischen Anlagen stehen zwangslufig bestimmte Teile der Gerte unter Spannung. Einige Teile knnen auch eine hohe Betriebstemperatur aufweisen.
Eine Nichtbeachtung dieser Situation und der Warnungshinweise kann zu Krperverletzungen und Sachschden fhren.
Deshalb wird vorausgesetzt, dass nur geschultes und qualifiziertes Personal die
Anlagen installiert und wartet.
Das System entspricht den Anforderungen der EN 60950 / IEC 60950. Angeschlossene
Gerte mssen die zutreffenden Sicherheitsbestimmungen erfllen.

Id:0900d8058027a761

DN985305
Issue 3-0

Key Map of Line Editor

Table of Contents
This document has 7 pages.
Summary of changes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
1

DN985305
Issue 3-0

Key map of line editor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Id:0900d8058027a761

Key Map of Line Editor

Id:0900d8058027a761

DN985305
Issue 3-0

Key Map of Line Editor

Summary of changes

Summary of changes
Changes between document issues are cumulative. Therefore, the latest document
issue contains all changes made to previous issues.
Changes made between issues 30 and 2a0
Editorial correction. No effect on the contents of the document.
Changes made between issues 2a and 2
The document has been revised to comply with the latest documentation standards, i.e.
minor textual modifications have been made.
No changes have been made in the document due to new features.
Changes made between issues 2 and 1
Information added on the use of arrow keys.

DN985305
Issue 3-0

Id:0900d805802fcc06

Key map of line editor

Key Map of Line Editor

1 Key map of line editor

INTERRUPTION OF MML
SESSION

BREAK

CTRL +

KEY FOR CHANGING

LANGUAGE

CTRL +

DELETION OF THE CHARACTER UNDER THE CURSOR

CTRL +

CURSOR TO THE BEGINNING

OF THE NEXT PARAMETER
BLOCK

CTRL +

PAGE/CONTINUOUS MODE

CTRL +

CONTINUATION OF OUTPUT

CTRL +

INTERRUPTION OF MML
COMMAND EXECUTION

CTRL +

OR DEL

CTRL +

CTRL +

CTRL +

MOVING CURSOR
TO THE LEFT

CTRL +

STOPPING OUTPUT

CTRL +

MOVING CURSOR TO
THE END OF BUFFER

CTRL +

OUTPUT TO PRINTER

CTRL +

MOVING CURSOR
TO THE RIGHT

CTRL +

EMPTYING LINE
BUFFER AND DISPLAY

CTRL +

MOVING CURSOR TO
THE NEXT LINE

CTRL +

INTERRUPTION OF
COMMAND INPUT

CTRL +

CTRL +

20 LINES OF LATEST
OUTPUT TO PRINTER

CTRL +

MOVING CURSOR TO
PREVIOUS LINE

CTRL +

DELETION OF CHARACTERS AFTER THE LINE

BUFFER CURSOR

CTRL +

OUTPUT OF ERROR
MESSAGE

CTRL +

SETTING MML PROGRAM

TO TEST STATE

CTRL +

CURSOR TO THE
BEGINNING OF THE
NEXT PARAMETER

CTRL +

HELP-TEXT

DELETION
OF PREVIOUS
CHARACTER

INSERT/REPLACE

SEARCH OF PREVIOUS
COMMAND FOR EDITING

MOVING CURSOR TO THE

BEGINNING OF BUFFER

Id:0900d80580317831

DN985305
Issue 3-0

Key Map of Line Editor

Key map of line editor

Arrow keys
right
arrow

MOVING CURSOR
TO THE RIGHT

left
arrow

up
arrow

DISPLAY THE COMMAND

ENTERED BEFORE THE ONE
WRITTEN AFTER THE PROMPT

down
arrow

up
arrow

CHARup
ACTER +
arrow
STRING

DN985305
Issue 3-0

LIST COMMANDS ENTERED NUMBER +

DURING MML SESSION AND
NUMBERS IDENTIFYING THEM

MOVING CURSOR
TO THE LEFT
DISPLAY THE COMMAND
ENTERED AFTER THE ONE
WRITTEN AFTER THE PROMPT
COMMAND
SEARCH A COMMAND
ENTERED DURING MML
up
arrow SESSION ACCORDING TO
COMMAND NUMBER

SEARCH A COMMAND ENTERED

DURING MML SESSION
ACCORDING TO CHAR. STRING

Id:0900d80580317831