Experiment2 18052012

EXPERIMENT-2
AIM: - To determine the alkalinity of a given water sample.

CHEMICALS USED: - N/10 HCl, phenolphthalein and methyl orange indicators, Sample water.
APPARATUS REQUIRED: - Burette, pipette, conical flask, beakers, funnel, and dropper
PRINCIPLE: - Alkalinity of water means the total content of those substances in it which causes an increased
OH- ion concentration up on dissociation or due to hydrolysis. The alkalinity of water is attributed to the
presence of
(i)
Caustic alkalinity( Due to OH- and CO32-)
(ii)
Temporary hardness ( Due to HCO3-)
Alkalinity is a measure of ability of water to neutralize the acids
Determination of alkalinity
2OH , CO3 and HCO3 can be estimated separately by titration against standard acid using phenolphthalein
and methyl orange as indicators
The determination is based on the following reactions
(i) OH- + H+
H2O
(ii) CO32- + H+
HCO3-
(iii) HCO3- + H+
H2O + CO2
The titration of water sample against a standard acid up to phenolphthalein end point (P) marks the
completion of reaction (i) and (ii) only. This amount of acid used thus corresponds to OH- plus one half of the
normal CO32- persent
On the other hand, titration of the water sample against a standard acid to methyl orange end point (M) marks
the completion of reaction (i), (ii) and (iii). Hence the total amount of acid used represent the total alkalinity.
Thus,
P = OH- + CO32M = OH- + CO32- + HCO3The table1 below shows the type and amount of alkalinity in water
S.No
1
2
3
4
5
Result of Titration
P=0
P=M
P=1/2M(V1=V2)
P>1/2M(V1>V2)
P<1/2M(V<V2)
OH- ion
nil
P or M
nil
2P-M
nil
CO32nil
nil
2P
2(M-P)
2P
PROCEDURE: 1. Pipette out 20 ml of water sample into a conical flask.

Phenolphthalein indicator.
2. Rinse and fill the burette with N/10 HCl.
3. Titrate the water sample in conical flask with N/10 HCl till
disappears.
4. Note down the reading and repeat to get concordant readings.
HCO3M
nil
nil
nil
M-2P
Add
the
1-2
pink
drops
color
of
just
5. Again take 20 ml of water sample in conical flask and add methyl orange
to it.
6. Titrate the water sample in conical flask with N/10 HCl till the yellow orange
changes to orange red.
7. Note down the reading and repeat to get concordant readings.
indicator
color
OBSERVATION TABLEs: a) Using Phenolphthalein (Table 2)

Normality of the acid used: N/10
S.NO.
1
2
3
Volume of the
solution taken in
the titration flask(in
mL)
20
20
20
Burette readings
Initial Reading
Volume of the
titrant used
Final Readings
Say V1ml =P
b) Using Methyl orange(Table 3)

Normality of the acid used: N/10
S.NO.
1
2
3
Volume of the
solution taken in
the titration flask(in
mL)
20
20
20
Burette readings
Initial Reading
Final Readings
RESULT: - Alkalinity of the given water sample is__ ppm.

PRECAUTIONS: 1. All glass wares should be properly washed.
2. Before use, rinse burette and pipette properly
3. Find the correct end point.
GENERAL CALCULATIONS: The volume required to neutralize particular ion can be calculated using table 1
For e.g.
P>1/2M i.e. V1>1/2V2
OH- and CO32- ions are present
From table 1
Volume of aid required to neutralize [OH-]= 2P-M i.e {2(V1) V2}mL
Volume of aid required to neutralize [CO32-]= 2(M-P) i.e 2(V2-V1)mL
Alkalinity due to OH-
Volume of the
titrant used
Say V2mL=M
Acid
N1V1
Water
N2V2 where V2=20mL
1/10{2(V1)-V2} = N2 X 20
N2=
2(V1)-V2
10 X 20
Strength = N2 X Eq. Wt of CaCO3 g/lt =
2(V1)-V2
X 50 X 103 mg/lt or ppm
200
In the same way the strength of other alkalinity causing ions can be calculated
QUESTION BANK:
1. Write structural formula of phenolphthalein. In what forms does it exist in acidic and alkaline form.
2. What is alkalinity of water? How is it estimated?
3. Why OH- and HCO3- ions cannot exist together in water
4. What are the draw backs of using highly alkaline water?
5. What is caustic embrittlement and what are its drawbacks?
6. What are the disadvantages of scale formation?
7. A200 ml of a water sample required 20 ml N/50 Sulphuric acid using methyl
orange as
indicator but did not give any coloration with phenolphthalein.
What type of
alkalinity is present? Express in mg/L.
Guidelines for preparation of solutions

1. Methy1 orange indicator: Dissolve 20mg of methyl orange in 100 ml of hot water. Allow to cool and
filter if necessary.
2. Phenolphthalein indicator: Dissolve 1g of Phenolphthalein in 100ml of 95% alcohol.
3. 0.1N HCl: Measure 10mL of Conc HCl (12N) in to one liter measuring flask. Pour 30mL distilled water
and shake. Add more distilled water to make the solution up to the mark. Stopper the flask and shake
vigorously
Safety Instructions
HCl :- It is poisnous and corrosive. Contact or inhalation can cause severe damage to the eyes, skin and
respiratory tract. Wear gloves and dispense under a hood, avoid contact and do not breathe the vapour

Experiment2 18052012

Uploaded by

Copyright:

Available Formats

Experiment2 18052012

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Experiment2 18052012

Uploaded by

Copyright:

Available Formats

EXPERIMENT-2

AIM: - To determine the alkalinity of a given water sample.

PROCEDURE: 1. Pipette out 20 ml of water sample into a conical flask.

OBSERVATION TABLEs: a) Using Phenolphthalein (Table 2)

b) Using Methyl orange(Table 3)

RESULT: - Alkalinity of the given water sample is__ ppm.

Strength = N2 X Eq. Wt of CaCO3 g/lt =

X 50 X 103 mg/lt or ppm

Guidelines for preparation of solutions

You might also like