Scribd
Upload
787 views2 pages

Teltronic MDT400

The MDT-400 is a powerful TETRA mobile terminal that supports mobility management, security classes 2 and 3, end-to-end encryption, and a wide range of voice and data services. It has options for GPS, GSM, programmable I/O, and air interface encryption. The terminal is versatile and can be configured for different uses through accessories like a remote control unit or operation without the front panel as a data modem.

Uploaded by

mollarri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
787 views2 pages

Teltronic MDT400

The MDT-400 is a powerful TETRA mobile terminal that supports mobility management, security classes 2 and 3, end-to-end encryption, and a wide range of voice and data services. It has options for GPS, GSM, programmable I/O, and air interface encryption. The terminal is versatile and can be configured for different uses through accessories like a remote control unit or operation without the front panel as a data modem.

Uploaded by

mollarri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MDT-400 TETRA MOBILE TERMINAL

MDT-400 SERVICES SUPPORTED


Mobility Management
- Registration / Deregistration
- All types of TETRA cell reselection (handover)
- AI migration & Multiple MNC (manual network selection)
Security Class 2 & 3
- Authentication (terminal and mutual)
- Air Interface Encryption Security Class:
- Class 1: Clear
- Class 2: SCK
- Class 3: DCK
- Algorithms: TEA1, TEA2 & TEA3
- OTAR (Over The Air Rekeying)
- Enable/Disable (Temporary and/ Permanent)
- PIN / PUK code
End to End encryption
- Voice E2EE (TMO & DMO).
- Full & Half duplex
- Individual & group
- Late Entry
- Data E2EE
- SDS
- GPS info
- Simultaneous ciphering of voice & SDS
Voice services
- Individual Half-duplex calls with Direct / Hook signalling
- Individual Duplex calls
- Group call: 1050 talkgroups (for TMO/DMO or both)
- Broadcast call
- Phone calls (PSTN/PABX). DTMF transmission
- Emergency call (type destination address programmable)

MDT-400
Data services
- Status to individual or group addresses
- SDS (type 1, 2, 3 and 4) to individual or group addresses
(with or without TL)
- Simultaneous Status & SDS Data on a Voice Call
- Immediate SDS
- PEI interface:
- AT commands
- TNP1 commands
- Different services profiles
- Packet Data (IP service)
- Circuit Data
Main Supplementary services
- Dynamic Group Number Assignment (DGNA)
- Late Entry (LE)
- Calling Line Identification (CLI)
- Calling Line Identification Restriction (CLIR)
- Talking Party Identification (TPI)
- Priority Call (PC)
- Call Forwarding (CF)
- Pre-emptive Priority Call (PPC)
- Access Priority (AP)
- Ambience Listening (AL)
Other features
- Transmit inhibit operation
- 112 / 999 emergency codes
- FSSN dialling / Simple offset dialling
- Engineering mode
- Discreet mode
- Logging request
- Audio accessories selection via menu
- MMI languages: European (English, Spanish, French,
German, Catalan, Dutch, Euskera, Polish, Portuguese),
Cyrillic (Russian), Chinese and Korean

TETRA MOBILE TERMINAL

professional personal communication

Powerful Technology for


professional communications

TECHNICAL CHARACTERISTICS

Dimensions
MDT-400: 177 x 163 x 47,5 mm (radio unit only)
195 x 163 x 61 mm (With front panel)
DT-410: 300 x 320 x110 mm
Weight
MDT-400: 1230 gr. (radio unit only)
1400 gr. (With front panel)
DT-410: 5 Kg.
Power Supply Voltage
MDT-400: 10,8 to 15,6 VDC
DT-410: 100 to 250 VAC
Consumption
4A ( 5A for 10W Tx RF)
DT-410 loudspeaker
3", 5W, 4 Ohms / Output to external speaker
RF Features
Chanel Spacing: 25KHz
Rx/Tx Bandwidth: 20MHz
Static/Dynamic Sensitivity: -112/-103 dBm
Receiver Class: A
Frequency bands
350-370MHz (10W) / 380-400MHz (10W) / 410-430MHz (10W)
450-470MHz (10W) / 806-870MHz (3W)

ENVIRONMENTAL
General
- According to ETSI EN 300 019 standard
- Operative temperature range: -30C to +70C
- Conformance Testing: ETSI EN300 394-1 (-20C to +55C)
- Storage temperature: -40C to +85C
- Humidity: 5% to 95%
- IP54
Classification according to ETSI EN 300 019 Standard
- Storage. Class 1.3. Non-weather protected storage locations.
- Transportation. Class 2.3. Public transportation.
- Stationary use (DT-410) Class 3.2. Partly temperature controlled
locations.
- Mobile use (MDT-400):
- Enviromental Class 5.2. Partly protected installations.
- Mechanical Class 5M3

Teltronic conducts continous reseach and development for all products and therefore reserves the right to modify equipment

Polgono Malpica, Calle F-Oeste


50057 Zaragoza (Spain)
Tels. +34 976 465656 +34 902 418016
Fax +34 976 465720
www.teltronic.es
E-mail: [email protected]
mdt400_ing_v7

MDT-400
TETRA MOBILE TERMINAL

MDT-400 TETRA MOBILE TERMINAL

MDT-400 TETRA MOBILE TERMINAL

POWERFUL

POWERFUL & FRIENDLY

Up to 10W RF output power


The output power is programmable from 15 mW up to 10W (40dBm) in 5dB steps. The 10W maximum
output power provides enhanced coverage, a key point in emergency and security situations.
Complete range of TETRA bands
The Teltronic mobile terminal is available in all the TETRA frequency bands on the market: 350-370,
380-400, 410-430, 450-470, 806-870 MHz
Improved audio quality
Improved audio quality according to PESQ (Perceptual Evaluation of Speech Quality, ITU-T recommendation
P.862).

Easy to use MMI


Features one of the easiest MMIs on the market, very intuitive and can be adapted
to any customers requirements, through short-cut keys and programmable keys.
The terminal is also available in a multiple variety of MMI languages: European
languages, Cyrillic, Chinese and Korean.
High quality display
Large 128x 64 dot matrix display making it easier to read data information and control
the terminal. Features also an automatic positive / negative mode, especially suitable
for any kind of lighting conditions (indirect, direct sunlight or low light conditions)
A configuration for each situation
Modern and ergonomic DT-410 unit specially designed for desktop use, with a full
range of accessories, and connection to an external battery.
Remote control unit for motorbikes designed taking into account ruggedness and
ease of operation.
Standard MDT-400 can also be operated without front panel as a Data Modem.

MDT-400 can be operated


as a Data Modem.

Remote front panel


mounting kit

POWERFUL & VERSATILE


Wide range of options
Programmable I/O option that includes audio line interface (600 Ohm E&M), and digital I/O lines, that
can be configured to send predefined calls.
Internal GSM option that enables to automatically change to GSM when the terminal travels outside the
TETRA coverage.
Internal GPS option, with shortened format and position information available via MMI and via PEI.
Very secure E2EE based in a tamperproof HW module. Several algorithms and market standards
available.
Special solutions for railways, underground, buses (AVLS),
Numerous references in various scenarios: buses, railways, undergrounds, light trains, using different
kinds of mechanical racks, audio configurations, PEI profiles, standarised Teltronic equipment for
complex requirements
The best option for system integrators
An enhanced PEI interface enables developed of all kind of applications such as GPS information,
database consult, files transmission or telemetry.
All data services defined in the TETRA standard are available (status, short data, packet data, circuit
mode data)
For AVLS projects optimised AVL algorithms improves the control channel efficiency to be able to
manage a greater amount of user terminals.

OPTIONS / ACCESSORIES
Options
- Internal GPS
- Internal GSM
- Air Interface Encryption SCK / DCK (TEA1, TEA2 & TEA3)
- E2EE
- Programmable I/O (includes all necessary hardware to allow a customised use):
- Line Interface (E&M)
- Audio Line Interface (600 Ohm)
- Ignition Control
- Mute Control / External horn relay
- Special events
- External PTT, AUX, HANG
- PEI control
Accessories
- Hands Free kit
- Fist Microphone with PTT and AUX
- Loud speaker 5W, 2
- Handset with PTT
- Remote control unit for motorbikes
- PEI connection kit
- Remote front panel mounting kit
- TETRA, GPS, GSM and combined antennas
Specific accessories for DT-410
- Desktop microphone with PTT, AUX buttons and Tx/Rx LEDs
- Foot-switched PTT
- Headset with boom microphone

You might also like