Scribd
Upload
1K views1 page

Reframag Af

Refratechnik Cement GmbH is a manufacturer of refractory materials located in Gottingen, Germany. REFRAMAG AF is a magnesia-spinel based refractory brick produced by Refratechnik. The brick has a bulk density between 2.85-3.00 g/cm3, apparent porosity of 15-17%, and cold crushing strength of 65 N/mm2. It also has a refractoriness under load over 1700°C and pyrometric cone equivalent greater than 42.

Uploaded by

mahreza189
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

Reframag Af

Refratechnik Cement GmbH is a manufacturer of refractory materials located in Gottingen, Germany. REFRAMAG AF is a magnesia-spinel based refractory brick produced by Refratechnik. The brick has a bulk density between 2.85-3.00 g/cm3, apparent porosity of 15-17%, and cold crushing strength of 65 N/mm2. It also has a refractoriness under load over 1700°C and pyrometric cone equivalent greater than 42.

Uploaded by

mahreza189
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Refratechnik Cement GmbH

Rudolf-Winkel-Strasse 1
D37079 Gottingen
Tel.+49 55169410
Fax.+49 551 6941104
e-mail [email protected]
www.refra.com

REFRATECHNIK

REFRAMAG AF
Raw material basis
Magnesia-Spinel

Physical properties
Bulk density g/cm3

2.85--3.00

Apparent porosity %

15--17

Cold crushing strength


2

N/mm

65

Refractoriness under load

ta

>1700

te

>1700

Pyrometric cone
equivalent S.C.

>42

Thermal expansion lin.-%


at 400

0.4

at 800

0.9

at 1200

1.5

thermal shock resistance


950 /air

100

Thermal conductivity
W/mK
at 300

4.0

at 700

3.0

at 1000

2.8

Chemical analysis
weight %
MgO

82--87

Al2O3

11--14

Fe2O3 approx.

0.8

CaO approx.

1.4

SiO2 approx.

0.9

Mortar
% weight of brick
AG-R mortar

1.5--4%

The stated values are qual-ity


characteristics deter-mined
for machine-pressed
standard shapes in accordance with or with reference
to DIN specifications.
They are typical standard
values, which cannot be
considered as binding
specifications. All prevopusly
published technical data
are replaced by the values
stated herein and thus
become invalid. kindly
follow our storage
instructions.
State 12/2002

You might also like